11 | Attaching Horizontal Track to |
|
|
|
Adjustable Flagangles |
|
| (2) 1/4” - 20 X 9/16” | |
|
|
| ||
| Flagangle |
| Track bolts | |
Tools Needed: | To install horizontal track, place the curved end over |
|
| |
|
|
| ||
the top roller. Align the bottom of the horizontal track |
|
|
| |
9/16” Socket |
|
|
| |
with the vertical track. Hand tighten the horizontal |
|
|
| |
Ratchet Wrench |
|
|
| |
track to the flagangle with (2) |
|
|
| |
9/16” Wrench |
|
|
| |
bolts and (2) |
|
|
| |
Level |
|
|
| |
|
|
|
| |
7/16” Socket | WARNING |
|
|
|
Step Ladder |
|
|
| |
| DO NOT RAISE DOOR UNTIL HORIZONTAL TRACKS | (2) 1/4” - 20 |
| Horizontal |
| ARE SECURED AT REAR, AS OUTLINED IN STEP 20, |
| ||
| Flange hex |
| ||
|
| track | ||
| OR DOOR COULD FALL FROM OVERHEAD POSITION |
| ||
| nuts |
| ||
|
|
| ||
| CAUSING SEVERE OR FATAL INJURY. |
|
| |
|
|
|
| |
| Level the horizontal track assembly and bolt the |
|
|
|
| horizontal angle to the slot in the flagangle using (1) |
|
|
|
|
|
|
| |
| nut. Repeat for other side. |
|
|
|
| Remove the nail that was temporarily holding the top | Flagangle |
|
|
| section in place, installed in Step 10. |
|
| (1) 3/8” - 16 X 3/4” |
|
|
|
| |
| IMPORTANT: Failure to remove nail before |
|
| Truss head bolt |
| attempting to raise door could cause | (1) 3/8” - 16 |
|
|
| permanent damage to top section. | Hex nut |
| Horizontal angle |
|
|
|
| |
12 |
|
|
| Horizontal |
|
|
|
| |
| Adjusting Top Brackets |
|
| track |
|
|
|
| |
Tools Needed: | With horizontal tracks installed, you can now adjust | Top |
|
|
the top brackets. Vertically align the top section of the | section |
|
| |
7/16” Wrench |
|
| ||
door with the lower sections. Once aligned, position |
|
|
| |
Step Ladder |
|
| Top | |
the top bracket slide, out against the horizontal track. |
|
| ||
|
|
| bracket | |
|
|
|
| |
| Maintaining the slide’s position, tighten the (2) 1/4”- |
|
| slide |
|
|
|
| |
| 20 flange hex nuts to secure the top roller slide to the |
|
| Top |
| top bracket base. |
| (2) 1/4”- 20 | |
|
|
| roller | |
|
|
| Flange hex nuts | |
|
|
|
| |
|
| Correct |
|
|
Top
section
14
Incorrect
Top section
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at
