Installation
Begin the installation of the door by checking the opening. It must be the same size as the door. Vertical jambs must be plumb and level with header. Side clearance, from edge of door to wall, must be a minimum of
IMPORTANT: Stainless STEEL OR PT 2000 Coated Lag SCREWS Must BE used When Installing CENTER Bearing Brackets, END Brackets, jamb Brackets, Operator Mounting/Support Brackets and DISCONNECT Brackets ON Treated Lumber
IMPORTANT: When installing 5/16” diameter lag screws using an electric drill/driver, the drill/driver’s clutch must be set to deliver no more than 200 in. lbs. of torque. Fastener failure could occur at a higher setting.
NOTE: It is recommended that 5/16” lag screws be pilot drilled using a 3/16” drill bit, prior to fastening.
1 | Lift Handle Installation | |
| ||
Tools Needed: | NOTE: For door section identification see page 4. | |
| ||
Tape Measure | Note: Use reference illustrations below for lift | |
Pencil | ||
handles positions on singles and double car garage. |
Lock section
Power Drill |
|
1/16” Drill Bit | Measure the width of the center stile which will |
| |
| receive the lift handle(s). Divide that measurement |
| in half and mark a vertical line on the center of the |
| stile. |
center stile
Locate the
centers
If you are installing two lift handles on the stile, |
you will need to measure from the edge of the |
center stile to the center line mark. Divide that |
measurement in half and draw a second and third |
vertical line parallel to the previously made center |
line mark. |
Measure the height of the panel. Divide that |
measurement in half and mark a horizontal line, |
intersecting the vertical line(s) previously marked. |
Measure up 3 7/8” from the intersecting line(s) and |
mark another horizontal line. |
Use the point(s) where the top horizontal line |
intersects the vertical line(s) to locate the top hole of |
the lift handle(s). |
Using the lift handle as a template, mark this |
location on the stile. Keeping the carriage handle |
aligned on the vertical line, mark the lower carriage |
handle hole on the stile. |
Drill a 1/16” pilot hole, then fasten both lift handles |
using #10 X 5/8” pan head self tapping screws. |
If the door came with two sets of lift handles repeat |
process. |
Locate the center
Single wide doors | Double wide doors |
| Horizontal line | Lift |
|
| |
| handles | |
|
|
#10 X 5/8” pan head self tapping screws
20” Min. To 30” max.
INSTALLATION
Lift handle placement reference on single wide doors
20” Min. To 30” max.
Lift handle placement reference on double wide doors
7
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at