Wayne-Dalton 6100 Pull Handle Installation, Pull handle placement reference on single wide doors

2	Pull Handle Installation
Tools Needed:	NOTE: For door section identification see page 4.
Tape Measure	Locate and mark the horizontal and vertical center
Pencil	on the bottom rail of the bottom section, on single
Power Drill	car doors.
1/16” Drill Bit
	Center the pull handle using the vertical and
	horizontal lines as reference on the bottom section
	rail as shown. Using the pull handle as a template,
	mark the two holes in the pull handle on the
	horizontal line of the bottom section rail. Drill a 1/16”
	pilot hole, then fasten pull handles using (2) #10 X
	5/8” pan head self tapping screws.
	If the door came with two pull handles, locate them
	directly below the lift handles and repeat installation
	process.
	Use reference illustrations below for lift handles
	positions on singles and double car garage doors.

Bottom section

Locate the	6” Max.
center

Bottom section

Pull handle

(2) #10 X 5/8” Pan head self tapping

screws

20” Min. To 30” max.

Pull handle placement reference on single wide doors

20” Min. To 30” max.

8

Pull handle placement reference on double wide doors

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com