|
|
| Winding Torsion Spring(s) |
|
|
| Continued... |
|
|
|
|
|
|
| Carefully remove winding bar from winding cone. |
| Tools Needed: |
| |
|
| Repeat for the opposite spring. While holding the | |
|
|
| |
|
|
| |
|
|
| door down, to prevent it from rising unexpectedly, in |
|
|
| the event the spring(s) were overwound, carefully |
|
|
| remove the vice grips from the torsion tube and the |
|
|
| vertical tracks. |
Important: cautiously remove vice clamps and vice grips from the torsion tube and vertical tracks.
| Adjustments to the required from the number of | Set |
|
| turns stated may be necessary. If door raises off |
| |
| floor under spring tension alone, Reduce spring | screws |
|
| tension until door rests on the floor. If the door is |
|
|
| hard to raise or drifts down on its own, add spring |
| Spring |
| tension. An unbalanced door such as this can cause |
| |
|
|
| |
| garage door opener operation problems. |
|
|
|
|
| Approved |
|
| Torsion | winding bars |
|
| Winding | |
|
| tube | cone |
20 | Rear Support | Door in the up |
|
|
| ||
WARNING | position |
| |
Tools Needed: |
|
| |
|
|
| |
Ratchet Wrench | Keep horizontal Track PARALLEL AND Within |
|
|
1/2” Socket |
|
| |
3/4” MAXIMUM Of DOOR EDGE, Otherwise DOOR |
|
| |
1/2” Wrench |
|
| |
COULD fall, RESULTING IN SEVERE death OR |
|
| |
(2) Vice Clamps |
|
| |
Injury. |
|
| |
|
|
| |
| Raise the door until the top section and half of the |
|
|
| next section are in a horizontal position. Do not raise |
|
|
| door any further since rear of horizontal track is not |
|
|
| yet supported. |
|
|
| WARNING |
|
|
| RAISING DOOR further her CAN RESULT IN DOOR |
|
|
| falling AND CAUSE SEVERE death OR Injury. |
|
|
| Clamp a pair of vice clamps on the vertical tracks |
|
|
| just above the second roller on one side, just below |
|
|
| the second roller on the other side. This will prevent |
| Vice |
| the door from raising or lowering while installing the | Vice | |
| clamp | ||
| rear support. | clamp | |
|
| ||
| Using perforated angle, 5/16” x |
| Vertical |
| lag screws and 5/16” bolts with nuts (may not be |
| |
|
| Track | |
| supplied), fabricate rear support for horizontal tracks. |
| |
|
|
| |
| Attach horizontal tracks to the rear supports with |
|
|
| 5/16”- 18 x |
|
|
| supplied). Horizontal tracks must be level and parallel |
|
|
| to door within 3/4” to 7/8” maximum of door edge. |
|
|
|
|
| 19 |
INSTALLATION
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at