Wayne-Dalton 9800 Series instruction

9800 Series (4 Section)

TorqueMaster® - Single and Double Spring(s)

Installation Instructions and Owner’s Manual

Wayne-Dalton, a Division of Overhead Door Corporation P.O. Box 67, Mt. Hope, OH 44660 www.Wayne-Dalton.com

IMPORTANT NOTICE!

Read these instructions carefully before attempting installation. If in question about any of the proce- dures, do not perform the work. Instead, have a qualified door agency do the installation or repairs.

Part No. 325115

REV4 09/02/2010

Page 1

Image 1

Wayne-Dalton 9800 Series installation instructions Series 4 Section, Important Notice

Contents

Important Notice Series 4 Section Table of Contents PRE-INSTALLATION Package Contents Door Section Identification Tools Required Power Drill3/16 Drill Bits Gloves Failure to use approved Torsion Spring Removal For Standard LiftWinding bars can cause spring Energy to be released Suddenly, resulting in severe Or fatal injury Unwind Springs Removal TorqueMaster SpringBracket and Drive Gear Removing the Old Door Extension Spring Removal Preparing the Opening Attaching Quick Install Flag Angle to Vertical Track InstallationTools Needed None Flagangle Horizontal Angle Be installed as shownTap the horizontal angle towards Aside Brackets Installing Q.I. Jamb Brackets Vertical Track Bottom Section Stacking Sections With the second set of holes from Top BracketsEndcap 20 x 5/8 carriage bolts Operator Bracket Top Section Do not Raise Door Until Attaching Horizontal Track toInjury Hex nuts This step Adjusting Top Brackets TorqueMaster Spring Tube Must install the center bracket bushingCenter Bracket Bushing Continue with Step Idrive opener on your garage door, you Idrive Installation Cable Drum Installation End Brackets Drive Gear InstallationTools Needed Lubricating Oil Repeat for left hand side.` Securing Center Bracket Assembly Counter InstallationInstallations on page 35, Figure B Repeat for left hand side for double spring applications Positioning Support Bracket Mounting Disconnect Attaching Disconnect CablesHandle Bracket Disconnect handle Disconnect handle. ThreadBracket Secure disconnect cable to Tools Needed Vice Clamp Cable AdjustmentsTools Needed Locking Pliers Flat Tip Screwdriver Important do not USE Impact GUN to Wind Springs Winding Bolt Rotation Setting Spring TensionRecommended Spring Turns Rear Support Drum Wrap InstallationKeep horizontal track Parallel and within 3/4 Maximum of door edge Attach horizontal tracks to the rear Adjust weather seal or door stop ifTools Needed Weather seal or door stop to both door DoorMaster TM Bracket Side Lock Pull Rope Tools Needed Power Drill Drill BitNo Scew EYE Pull Rope Bottom Bracket Operator Must be Tested AT Time Trolley OperatorResult in Severe or Fatal Injury Door is fully open trolley rail will Glass Cleaning Instructions Cleaning Your Steel And Fiberglass Garage DoorAcrylic Cleaning Instructions Important do not USE a Pressure Washer on Garage Door Fiberglass Refinishing And Or Finishing Steel Preparation For Painting Thank you for your purchase Lifetime Limited Warranty Model