Pull Rope

Tools Needed:

Power Drill

1/8” Drill Bit

WARNING

DO NOT INSTALL PULL ROPES ON DOORS WITH ELECTRIC OPERATORS. CHILDREN MAY BECOME ENTANGLED IN THE ROPE CAUSING SEVERE OR FATAL INJURY.

Measure and mark the jamb approximately 48” to 50” (1220 to 1270

mm)from floor on the right or left side of jamb. Drill 1/8” pilot hole for No. 6 screw eye. Tie the pull rope to the No. 6 screw eye and to the bottom bracket as shown.

NO. 6 SCEW EYE

PULL ROPE

BOTTOM BRACKET

PULL ROPE

36Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts

You May Need.You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.Wayne-Dalton.com

Page 36

Image 36

Wayne-Dalton 9800 Series Tools Needed Power Drill Drill Bit, No Scew EYE Pull Rope Bottom Bracket

Contents

Series 4 Section Important Notice Table of Contents Package Contents PRE-INSTALLATION Door Section Identification Power Drill Tools Required3/16 Drill Bits Gloves Torsion Spring Removal For Standard Lift Failure to use approvedWinding bars can cause spring Energy to be released Suddenly, resulting in severe Or fatal injury Unwind Springs TorqueMaster Spring RemovalBracket and Drive Gear Extension Spring Removal Removing the Old Door Preparing the Opening Installation Attaching Quick Install Flag Angle to Vertical TrackTools Needed None Flagangle Be installed as shown Horizontal AngleTap the horizontal angle towards Aside Brackets Installing Q.I. Jamb Brackets Bottom Section Vertical Track Stacking Sections Top Brackets With the second set of holes fromEndcap 20 x 5/8 carriage bolts Operator Bracket Top Section Attaching Horizontal Track to Do not Raise Door UntilInjury This step Hex nuts Adjusting Top Brackets Must install the center bracket bushing TorqueMaster Spring TubeCenter Bracket Bushing Continue with Step Idrive opener on your garage door, you Idrive Installation Cable Drum Installation Drive Gear Installation End BracketsTools Needed Lubricating Oil Repeat for left hand side.` Counter Installation Securing Center Bracket AssemblyInstallations on page 35, Figure B Repeat for left hand side for double spring applications Positioning Support Bracket Attaching Disconnect Cables Mounting DisconnectHandle Bracket Disconnect handle. Thread Disconnect handleBracket Secure disconnect cable to Cable Adjustments Tools Needed Vice ClampTools Needed Locking Pliers Flat Tip Screwdriver Important do not USE Impact GUN to Wind Springs Setting Spring Tension Winding Bolt RotationRecommended Spring Turns Drum Wrap Installation Rear SupportKeep horizontal track Parallel and within 3/4 Maximum of door edge Adjust weather seal or door stop if Attach horizontal tracks to the rearTools Needed Weather seal or door stop to both door Side Lock DoorMaster TM Bracket Tools Needed Power Drill Drill Bit Pull RopeNo Scew EYE Pull Rope Bottom Bracket Trolley Operator Operator Must be Tested AT TimeResult in Severe or Fatal Injury Door is fully open trolley rail will Cleaning Your Steel And Fiberglass Garage Door Glass Cleaning InstructionsAcrylic Cleaning Instructions Important do not USE a Pressure Washer on Garage Door Steel Preparation For Painting Fiberglass Refinishing And Or Finishing Lifetime Limited Warranty Model Thank you for your purchase

Wayne-Dalton 9800 Series installation instructions Pull Rope, Tools Needed Power Drill Drill Bit

Models: 9800 Series

Tools Needed:

Power Drill

1/8” Drill Bit

Pull Rope

NO. 6 SCEW EYE

PULL ROPE

BOTTOM BRACKET