|
|
|
| |
14 |
| Attaching Horizontal Track to | ||
|
| Adjustable Flagangle | ||
| NOTE: If quick install flagangles were | |||
Tools Needed: | ||||
9/16” Socket | installed in Step 13, skip this step and | |||
continue with Step 15. If not, complete | ||||
7/16” Socket | ||||
this step. | ||||
| ||||
Ratchet Wrench | To install horizontal track, place the | |||
9/16” Wrench | ||||
curved end over the top roller. Align | ||||
Level | ||||
the bottom of the horizontal track with | ||||
Flat tip | ||||
the vertical track. Hand tighten the | ||||
Screwdriver | horizontal track to the flagangle with | |||
(1) stud plate and (2) 1/4” - 20 flange | ||||
| ||||
| hex nuts. | |||
|
|
|
| |
|
| WARNING | ||
| DO NOT RAISE DOOR UNTIL | |||
| HORIZONTAL TRACKS ARE SECURED | |||
| AT REAR, AS OUTLINED IN STEP 33, OR | |||
| DOOR COULD FALL FROM OVERHEAD | |||
| POSITION CAUSING SEVERE OR FATAL | |||
| INJURY. | |||
| Level the horizontal track assembly and | |||
| bolt the horizontal angle to the slot in | |||
| the flagangle using (1) 3/8” - 16 x 3/4” | |||
| truss head bolt and (1) 3/8” - 16 hex | |||
| nut. Repeat for other side. Remove the | |||
| nail that was temporarily holding the | |||
| top section in place, installed in Step | |||
| 12. |
| ||
| IMPORTANT: Failure to remove nail | |||
| before attempting to raise door | |||
| could cause permanent damage | |||
| to top section. | |||
| NOTE: If an idrive® opener will be | |||
| installed, position horizontal tracks | |||
| slightly above level. | |||
|
|
|
| |
Flagangle | Stud |
| plate |
1/4” - 20 |
|
flange hex |
|
nuts |
|
| INSTALLATION |
flagangle |
|
3/8” - 16 X 3/4” | 3/8” - 16 Hex nut |
| |
TRUSS HEAD BOLT |
|
| hORIZONTAL ANGLE |
| HORIZONTAL |
| TRACK |
Please Do Not Return This Product To The Store. Contact your local
