Adjusting Top Brackets

15	Adjusting Top Brackets
	Adjusting Top Brackets

Tools Needed:	With horizontal tracks installed, you can
7/16” Wrench	now adjust the top brackets.
	Vertically align the top section of the
	door with the lower sections. Once
	aligned, position the top bracket slide,
	out against the horizontal track.
	Maintaining the slide’s position, tighten
	the (2) 1/4” - 20 flanged hex nuts to
	secure the top roller slide to the top
	bracket base.

HORIZONTAL

track

top
SECTION	TOP BRACKET
	TOP BRACKET
	SLIDE

(2)1/4” - 20

FLANGED HEX

NUTS

Correct

top

section

inCorrect

22Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local

yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

Page 22

Image 22

Wayne-Dalton 9800 Series installation instructions Adjusting Top Brackets

Contents

Series 4 Section Important Notice Table of Contents Package Contents PRE-INSTALLATION Door Section Identification 3/16 Drill Bits Power DrillTools Required Gloves Winding bars can cause spring Energy to be released Torsion Spring Removal For Standard LiftFailure to use approved Suddenly, resulting in severe Or fatal injury Unwind Springs Removal TorqueMaster SpringBracket and Drive Gear Extension Spring Removal Removing the Old Door Preparing the Opening Tools Needed None InstallationAttaching Quick Install Flag Angle to Vertical Track Flagangle Tap the horizontal angle towards Be installed as shownHorizontal Angle Aside Brackets Installing Q.I. Jamb Brackets Bottom Section Vertical Track Stacking Sections Endcap Top BracketsWith the second set of holes from 20 x 5/8 carriage bolts Operator Bracket Top Section Do not Raise Door Until Attaching Horizontal Track toInjury This step Hex nuts Adjusting Top Brackets Center Bracket Bushing Must install the center bracket bushingTorqueMaster Spring Tube Continue with Step Idrive opener on your garage door, you Idrive Installation Cable Drum Installation Tools Needed Lubricating Oil Drive Gear InstallationEnd Brackets Repeat for left hand side.` Installations on page 35, Figure B Counter InstallationSecuring Center Bracket Assembly Repeat for left hand side for double spring applications Positioning Support Bracket Mounting Disconnect Attaching Disconnect CablesHandle Bracket Bracket Disconnect handle. ThreadDisconnect handle Secure disconnect cable to Tools Needed Locking Pliers Flat Tip Screwdriver Cable AdjustmentsTools Needed Vice Clamp Important do not USE Impact GUN to Wind Springs Winding Bolt Rotation Setting Spring TensionRecommended Spring Turns Keep horizontal track Drum Wrap InstallationRear Support Parallel and within 3/4 Maximum of door edge Tools Needed Adjust weather seal or door stop ifAttach horizontal tracks to the rear Weather seal or door stop to both door Side Lock DoorMaster TM Bracket Pull Rope Tools Needed Power Drill Drill BitNo Scew EYE Pull Rope Bottom Bracket Result in Severe or Fatal Injury Trolley OperatorOperator Must be Tested AT Time Door is fully open trolley rail will Acrylic Cleaning Instructions Cleaning Your Steel And Fiberglass Garage DoorGlass Cleaning Instructions Important do not USE a Pressure Washer on Garage Door Steel Preparation For Painting Fiberglass Refinishing And Or Finishing Lifetime Limited Warranty Model Thank you for your purchase

bracket base.

FLANGED HEX

NUTS

Correct

top

section

inCorrect