Wayne-Dalton 9800 Series TorqueMaster Spring Tube, Center Bracket Bushing, Labeled END

16

Tools Needed:

None

TorqueMaster® Spring Tube

TorqueMaster® springs come lubricated and pre-assembled inside the Torquemaster® spring tube. To install, lay the Torquemaster® spring tube on the floor (inside garage) in front of the door with the labeled end to the left.

Important: RIGHT AND LEFT HAND IS ALWAYS DETERMINED FROM INSIDE THE GARAGE LOOKING OUT.

TorqueMaster®

Spring Tube

LABELED END

17	Center Bracket Bushing	CENTER
		BRACKET
		ASSEMBLY
Tools Needed:	NOTE: If you are installing the idrive®
	opener on your garage door, skip this step
	and continue with Step 18.
	NOTE: If you are not installing the
	idrive® opener on your garage door, you	TorqueMaster®
	must install the center bracket bushing	Spring Tube
	assembly. Follow these instructions for
	non-idrive®operated garage doors.
	NOTE: If you are installing a DoorMaster™
	opener, see optional DoorMaster™	TorqueMaster®
	Bracket installations on page 35, Figure A.
		Spring Tube

Being cam shaped the center bracket bushing only fits one way.

Slide the center bracket assembly towards the center of the Torquemaster® spring tube, from the right side as shown.

NOTE: Upon completion of this step,	CENTER
	BRACKET
continue with Step 19.	BUSHING

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local 23 yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com

INSTALLATION