Wayne-Dalton 9800 Series Drive Gear Installation, End Brackets, Tools Needed Lubricating Oil

20

Tools Needed:

Lubricating Oil

Drive Gear Installation

Beginning with the right hand side, lubricate entire circumference of the drive gear with the lubricating oil provided. Slide the drive gear onto the winding shaft splines until it touches the flagangle.

NOTE: On single spring applications, no drive gear is required on the left side.

NOTE: If additional lubricating oil is needed, use “Dura Lube® Engine Oil Treatment”.

Cable

Drum

Winding lubricating

Shaftoil

Splines

Flagangle Drive

Gear

Cable

Drum

Drive

Gear

Winding

Shaft

21

Tools Needed:

Power Drill

3/16” Drill Bit

7/16”

Socket Driver

Phillips Head

Screwdriver

End Brackets

IMPORTANT: Warning Tags must be securely attached to both End Brackets.

Slide the right hand end bracket over the drive gear and fasten to the flagangle using a #10 self-tapping screw. Drill 3/16” pilot holes into jamb for the lag screws. Secure end bracket and the flagangle to the jamb using (2) 5/16” x 1-5/8" lag screws.

Repeat for left hand side.`

End Bracket

(2) 5/16” x 1-5/8” Lag Screws

Warning

Tag

#10 Phillips

Head

Screw

26Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local

yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com