Installing Hot Swap Drive(s)
1.Press in on the green latch (see letter “A” in the following figure) at the end of the drive carrier to disengage it from the hot swap drive cage.
2.Pull out on the black lever (see letter “B”) to fully open the drive carrier. When the lever reaches a fully opened position, it will push the drive carrier out from the hot swap drive cage. Slide the drive carrier out of the drive cage (see letter “C”).
A
B
C
AF000589
Figure 45. Removing Drive Carrier from Hot Swap Cage
3.Remove the four screws that secure the plastic air baffle to the drive carrier. Remove the plastic air baffle.
AF000590
Figure 46. Removing Plastic Air Baffle
4.Secure the hard drive to the drive carrier using the four screws that were formerly attached to the plastic air baffle. Ensure that the connector end of the hard drive is facing the back of the drive carrier. The label side of the hard drive should be facing up in the drive carrier.
44 | Intel® Server Chassis SC5400 User’s Guide |
