Removing and Installing the Front Bezel

Removing the Bezel Assembly (Pedestal Only)

Caution: Do not rotate the bezel assembly more than 40 degrees or you will damage the bezel assembly.

Note: The bezel assembly consists of two components, a front door and a sub-bezel.

1.Observe the safety and ESD precautions at the beginning of this book.

2.Power down the server and unplug all peripheral devices and the AC power cable.

3.Remove the chassis cover. For instructions, see “Removing the Chassis Cover” on page 16.

4.Release the two plastic tabs (see letter “A” in the following figure) on the left side of the bezel assembly to disengage the tabs.

5.Rotate the bezel assembly (see letter “B”) no more than 40 degrees outward.

6.At a 40-degree angle, push the bezel assembly away from the chassis (see letter “C”).

7.If the bezel assembly does not immediately disconnect from the chassis, tap the left-hand side of the bezel assembly to disengage the bezel hooks on the right-hand side of the chassis.

A

C

A

B

AF000557

Figure 9. Removing the Front Bezel

18

Intel® Server Chassis SC5400 User’s Guide

Page 36
Image 36
Intel SC5400 manual Removing and Installing the Front Bezel, Removing the Bezel Assembly Pedestal Only