13 |
| Attaching Horizontal Track to | |
|
| Quick Install Flagangle | |
|
|
|
|
Tools Needed: | NOTE: If you have fully adjustable | ||
9/16” Socket | flagangle, skip this step and complete | ||
Ratchet Wrench | Step 14. | ||
|
|
| |
9/16” Wrench | To install horizontal track, place the | ||
Level | curved end over the top roller. Align | ||
| key slot of the horizontal track with the | ||
| quick install tab of the flagangle. Push | ||
| curved portion of horizontal track down | ||
| to lock in place. | ||
|
|
|
|
|
| WARNING | |
| DO NOT RAISE DOOR UNTIL | ||
| HORIZONTAL TRACKS ARE SECURED | ||
| AT REAR, AS OUTLINED IN STEP 33, OR | ||
| DOOR COULD FALL FROM OVERHEAD | ||
| POSITION CAUSING SEVERE OR FATAL | ||
| INJURY. | ||
| Level the horizontal track assembly and | ||
| bolt the horizontal angle to the slot in | ||
| the flagangle using (1) 3/8” - 16 x 3/4” | ||
| truss head bolt and (1) 3/8” - 16 hex | ||
| nut. Repeat for other side. Remove the | ||
13 | nail that was temporarily holding the | ||
12. |
| ||
| top section in place, installed in Step | ||
| IMPORTANT: Failure to remove nail | ||
| before attempting to raise door | ||
| could cause permanent damage | ||
| to top section. | ||
| NOTE: If an idrive® opener will be | ||
| installed, position horizontal tracks | ||
| slightly above level. | ||
| NOTE: After completing this step, | ||
| continue with Step 15. | ||
|
|
|
|
horizontal | flagangle |
track |
|
key slot |
|
QUICK |
|
INSTALL |
|
TAB |
|
vertical |
|
track |
|
horizontal | flagangle |
track | |
QUICK |
|
INSTALL |
|
TAB |
|
key slot |
|
vertical |
|
track |
|
flagangle |
|
3/8” - 16 X 3/4” | 3/8” - 16 Hex nut |
| |
TRUSS HEAD BOLT |
|
| hORIZONTAL ANGLE |
| HORIZONTAL |
| TRACK |
20Please Do Not Return This Product To The Store. Contact your local
yellow pages business listings or go to the Find a Dealer section online at
