Advanced Installation Information
Celsius/Fahrenheit Readout
Modify your display to read degrees C or degrees F:
To display degrees Celsius:
1.Install jumper on jumper JP1 position A shown in diagram to the right.
2.Press and release the RESET button (using a paper clip or pencil point) on the front of the control unit to activate your setting.
To display degrees Fahrenheit:
1.Do not install jumper or remove jumper on jumper JP1 as shown on position B in the diagram to the right.
2.Press and release the RESET button on the front of the control unit to activate your setting.
JP1
A
OR
B
2 | |
|
JP1
RESET
NORMAL | SAVE |
| ENERGY |
20
Temperature Offset
Your
to force the thermostat to match another thermometer in your home to a maximum of +/- 6º.
1.Remove Thermostat Control Unit from the thermostat base.
2.Slide the calibration switch to the ON position.
3.Press either the + or - button on the front of the Control Unit until the desired temperature offset factor is reached.
4.Slide the Calibration switch to the OFF position.
NOTE: If using this feature, Temperature Offset must be adjusted each time the thermostat is RESET or batteries are removed.
OFF | ON |
2 | | ON |
| | Calibrate |
|
| |
4 |
| OFF switch |
| CALIB |
|
3
Example: Display shows +2 degree Offset factor