Wayne-Dalton WDTC-20 On the Wireless Gateway, press, Operating Thermostat, Programming Examples

Z-Wave®Programming

Example with WDHA-12R

4.On the Wayne-Dalton Z-Wave®Enabled Thermostat press the SAVE ENERGY mode. The thermostat must be in either HEAT or COOL, SAVE ENERGY mode, to be added to the network correctly.

5.On the Wireless Gateway, press

and hold the SCENE button you wish to program, (either Scene 1, 2 or 3 but choosing a different SCENE than in Step

2)for SAVE ENERGY mode. The LED on the Wireless Gateway will turn on immediately, then turn off, then turn on again.

6.While holding the desired SCENE button on the Wireless Gateway, press and release the BIND button on the thermostat.

The LED on the Wireless Gateway will flash three (3) times quickly to indicate the programming is successful. Do not release the Scene button until you see the LED’s flash (30 second max wait.)

Thermostat programming to the Wireless Gateway is now complete.

OPERATING THERMOSTAT:

1. Place the thermostat in either the HEAT or COOL mode by manually pressing the appropriate button.

2.Press the controller SCENE button you programmed for NORMAL target temperature to activate the NORMAL mode, or press the controller SCENE button you programmed for SAVE ENERGY to activate the SAVE ENERGY mode.

See the Wireless Gateway User Manual for directions on operating Scenes and key chain remote operation.

REMOVING THERMOSTAT FROM WIRELESS GATEWAY (primary controller):

Remove the thermostat from the Wireless Gateway as you would remove any Z-Wave®module. Use the BIND button the same as the PROGRAM button, to activate the Z-Wave®signal. See the Wireless Gateway User Manual for specific instructions.

COOL
RESET
			AUTO
NORMAL SAVE		HEAT
	ENERGY		COOL
			FAN

4

5		Scene	1
		Scene 2
		Scene 3
		Copy
		Delete

6 

COOL

RESET

NORMAL SAVE

ENERGY

Programming Examples

31