Step 4: Wiring Information
General wiring guidelines for safe and secure wire connections:
•Ends of wires should be stripped 3/8 inch as shown.
• Take care not to damage or lose labels for each wire during handling.
•Locate and dress wires to come in from behind the thermostat and turn up into the terminal area.
• Push excess wiring back into the wall | Terminal Block | |
opening. Do not allow wiring between | ||
in Mounting | ||
thermostat mounting base and wall. | ||
Base | ||
• Connect labeled wires only to a terminal | ||
| ||
with a corresponding letter. |
|
Note: Be careful, do not allow bare |
|
wires to touch, or short, each other. |
|
• Use the wiring diagrams on page 12 and |
|
cross reference chart on page 13 for your | Wiring Strip |
exact application as your guide. | length is 3/8 |
• Fan wires out as illustrated in the wiring | inch |
diagrams with the |
|
thermostat mounting base positioned below |
|
the wall opening. |
|
•Insert the wire in the terminal and tighten the screw securely.
•Set the control unit configuration jumpers per the Wiring and Jumper configurations found on pages
matches your wiring needs. A |
| JP1 JP2 | |
pliers may be required to remove the jumper |
| ||
JP5 |
| ||
to modify its position. | JP3 | ||
| |||
|
| JP4 |
Note: Numbered Jumper Locations JP1 - JP5 are referenced in illustration above and in the wiring diagrams on the following pages.
Continued Next Page
Installation
9