Installation
8
Step 3: Mounting Thermostat
Tools required:
Phillips or Slotted Screwdriver Drill
3/16 inch drill bit Hammer Pencil
1.Separate the control unit (front) of the thermostat from the mounting base (back.) Grasp the thermostat and pry the control unit away from the base, lift up to remove the control unit from the base as shown. Set aside the control unit.
2.Pull the wires through the wire hole in the base.
Note: Be careful, do not allow bare wires to touch, or short, each other.
3.Hold the base against the wall with the wires coming through the opening below the terminal block, and position the base for best appearance. Mark the hole positions with a pencil or mount directly to the wall with the two screws provided.
If mounting the base to sheetrock or if using the existing mounting holes, use the plastic anchors provided. Drill a 3/16 in (4.8 mm) hole for the anchors at each screw location. Use a hammer to tap the screw anchors into the hole. Mount the base with the two screws provided.
Note: This thermostat does not require leveling for proper operation.
4.Be certain all wires are threaded through the hole in the thermostat base. Leave wires loose in the opening.
Note: Be careful, do not allow bare wires to touch, or short, each other.
Thermostat
Control Unit 
Thermostat |
| |
Mounting | | |
Base | ||
| ||
| Lift up Control | |
| unit from Base |
Thermostat |
| Wall Opening |
Mounting |
|
|
|
| |
Base |
|
|
G | w |
| |
B |
|
Screws 
Continued Next Page
