Installation
Step 8: Control Unit Preparation
Prepare the | 1 | |
Thermostat Control Unit for | ||
| ||
Installation: |
|
1. Install 2 AA batteries as shown in the diagram to the right. The batteries are required to maintain your target temperatures during a power outage. If battery power is lost, or when changing batteries, you must reset your target temperatures.
NOTE: Use Alkaline Batteries only, do not use rechargeable batteries.
NOTE: Replace the batteries if the low battery indicator icon is displayed.
OPERATION NOTE: If the batteries die during a power outage, when AC power is restored the thermostat will power up in the OFF state.
2.Press and release the RESET button on the front of the control unit to initialize your jumper settings. If jumper settings are changed, you must press the RESET button.
| + AA | - | + AA | - |
| ||||
|
|
|
SAVE HEAT
Low Battery Icon
Located on Thermostat
LCD Display
2 | |
|
|
|
|
| |
|
| RESET |
|
|
| NORMAL | SAVE |
|
|
| ENERGY |
18
Step 9: Control Unit Installation
Install the
1.Install the Thermostat Control Unit to the thermostat base in the following manner:
a) Hook the top of the Control Unit to the thermostat base.
b) Swing the unit down until it snaps in position.
c) Push firmly on the center of the Control Unit to ensure the electrical contacts are mated properly.
NOTE: After handling, the control unit may require up to one hour to stabilize to room temperature.
1
COOL
2