Wayne-Dalton WDTC-20 user manual Installation

Step 10: Installation Verification

Verify you have correctly installed the Z-Wave®Enabled Thermostat:

1.Restore Power: Turn on all electrical power turned off in Step 1.

2.Check Fan:

NOTE: Do this only if during installation the G wire or the fan relay was connected, otherwise proceed to 3.

A.Slide fan switch to the ON position.

B.Verify air is blowing from your system.

C.Return to AUTO position for Normal operation.

3. Check Heat:

Installation

	3B
COOL

A.Press and release the HEAT button on the front of the control unit. The word HEAT will appear in the display.

B.Press the “+” symbol (Temperature up) button to raise the temperature to 90 degrees F.

C.Wait 5 minutes, then verify warm air is blowing from your system.

D.Press and release the HEAT button to shut off the heat.

4. Check Air Conditioning:

NOTE: Wait 5 minutes after doing the Heat Check, before proceeding.

A.Press and release the COOL button on the front of the control unit. The word COOL will appear in the display.

B.Press the “-”symbol (Temperature down) button to lower the temperature 5 degrees less than the current reading.

C.Wait 5 minutes, then verify cool air is blowing from your system.

D.Press and release the COOL button to shut off the cooling system.

NOTE: If any of these checks do not function properly, review your wiring and jumper configuration. If the problem persists, contact customer support for assistance.

Installation of your Wayne-Dalton Z-Wave®Enabled Thermostat is complete. Go to Page 21 for Operation and Programming information.

4B

RESET

NORMAL SAVE	HEAT	AUTO
ENERGY		COOL

3A	
3D		4A
		4D

ON

FAN 2A

2C

19