Wayne-Dalton WDTC-20 user manual Programming, Continued Next Page

Programming Target temperatures

Target temperatures are programmed into the thermostat as the desired temperature for the mode being programmed. A total of four modes are available for programming:

a)Normal Heat, b) Save Heat,

c)Normal Cool, d) Save Cool

NORMAL modes are used when the
home is occupied, and SAVE ENERGY
modes are used for when the home		
is unoccupied. The SAVE ENERGY	1
mode is a pre-determined set-back
temperature.

1.FOR FIRST TIME SET-UP ONLY: Press and release the RESET button (use a paper clip or pencil point) to initialize the jumper settings and reset the target temperatures to default settings.

After reset the thermostat will be in the OFF state.

NOTE: If this is not the first time set-up, place your thermostat into the OFF position. If the display is showing the word COOL, press the COOL button to turn the unit off. If the display is showing the word HEAT, press the HEAT button to turn the unit off.

Programming NORMAL HEAT target
temperature:
2. Press and release the HEAT button.
HEAT will appear in the display.
3. Press and release the NORMAL
button. TARGET TEMP will appear in
the display.		
4. The default NORMAL HEAT target	4
temperature is 70º F. To accept the
default temperature wait 5 seconds
and the unit will exit target temperature
programming mode. If the default
setting is not desired, press either the
temperature up button (+ symbol) or
temperature down button (- symbol)
until the desired target temperature
is reached. Wait 5 seconds and
the unit will exit target temperature
programming mode and save your
settings and display the ROOM TEMP.

Programming

COOL

RESET

NORMAL SAVE	HEAT	AUTO
ENERGY		COOL

FAN

	HEAT
	RESET
				AUTO
	NORMAL SAVE		HEAT
		ENERGY		COOL
3	
	2

RESET

NORMAL SAVE	HEAT
ENERGY

Continued Next Page

23