SEAR STATION® TROUBLESHOOTING
PROBLEM | CHECK | SOLUTION | |
|
|
| |
Burners burn with a yellow or orange flame, in | Inspect spider/insect screens for possible obstructions.. | Clean spider/insect screens.. | |
conjunction with the smell of gas. (This is normal for | (Blockage of holes..) | Refer to “ANNUAL MAINTENANCE..” | |
the burner lighting tube.) |
|
| |
Did you ignite the two adjacent main burners? Refer to | Verify adjacent main burner ignition by visual inspection | ||
Sear Station® burner does not light. | |||
“SEAR STATION® IGNITION & USAGE” for safe lighting | of a flame.. | ||
| procedure.. | m WARNING: If ignition does not occur | |
|
| ||
|
| in five seconds, turn burner control | |
|
| OFF, wait five minutes to let the gas | |
|
| clear before you try again. | |
|
|
| |
| Does burner light with a match? | If you can light burner with a match, then check the | |
|
| Crossover® Channel on the sear burner.. | |
|
| Refer to “MAINTENANCE” for burner removal and | |
|
| cleaning procedure.. | |
|
|
| |
| Does the igniter work? Do you see a spark when you | Try manually lighting the burner.. Refer to “SEAR | |
| repeatedly use the snap igniter? | STATION® IGNITION & USAGE..” Call Customer Service.. | |
|
|
| |
General Symptoms: | The excess flow safety device, which is part of the | To reset the excess flow safety device, turn all burner | |
Burner does not light. | barbecue to cylinder connection, may have been | control knobs and the cylinder valve to OFF.. Disconnect | |
activated.. | the regulator from the cylinder.. Turn burner control knobs | ||
OR | |||
| to START/HI.. Wait at least one minute.. Turn burner | ||
Burner has a small flickering flame. |
| ||
| control knobs to OFF.. Reconnect the regulator to the | ||
|
| ||
|
| cylinder.. Turn cylinder valve on slowly.. Refer to “MAIN | |
|
| BURNER IGNITION..” | |
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
ROTISSERIE TROUBLESHOOTING
PROBLEM | CHECK | SOLUTION | |
|
|
| |
Rotisserie burner does not light. | Did you hold the burner control knob in and hold in for 20 | Try to relight burner by holding burner control knob in; | |
| seconds after burner ignited? | continue holding in until 20 seconds after burner has | |
|
| ignited.. | |
|
|
| |
| Did you wait to see the entire ceramic surface become | When relighting burner by holding burner control knob | |
| alight before counting 20 seconds? | in, wait to see the entire ceramic surface become alight | |
|
| before counting 20 seconds.. | |
|
|
| |
| Did you repeatedly use the snap ignition until the burner | After waiting five minutes for gas to clear, try using the | |
| ignited? | snap igniter repeatedly until the burner ignites.. Refer to | |
|
| “ROTISSERIE BURNER IGNITION & USAGE..” | |
|
|
| |
| Does the igniter work? Do you see a spark when you | Try manually lighting the burner.. Refer to “ROTISSERIE | |
| repeatedly use the snap igniter? | BURNER MANUAL IGNITION..” Call Customer Service.. | |
|
|
| |
General Symptoms: | The excess flow safety device, which is part of the | To reset the excess flow safety device, turn all burner | |
Burner does not light. | barbecue to cylinder connection, may have been | control knobs and the cylinder valve to OFF.. Disconnect | |
activated.. | the regulator from the cylinder.. Turn burner control knobs | ||
OR | |||
| to START/HI.. Wait at least one minute.. Turn burner | ||
Burner has a small, flickering flame. |
| ||
| control knobs to OFF.. Reconnect the regulator to the | ||
|
| ||
|
| cylinder.. Turn cylinder valve on slowly.. Refer to “MAIN | |
|
| BURNER IGNITION..” | |
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
GRILL OUT™ HANDLE LIGHT TROUBLESHOOTING
PROBLEM | CHECK | SOLUTION |
|
|
|
Weber Grill Out™ Handle Light does not light. | Are the batteries old? | Replace batteries.. |
|
|
|
| Are the batteries installed correctly? | Refer to assembly illustration.. |
|
|
|
| Is the lid in the up position with the power button ON? | Light will activate when lid is open.. |
|
|
|
| Is the Weber® Grill Out™ Handle Light activated? | Press the power button.. |
|
|
|
| Is the Weber® Grill Out™ Handle Light positioned | Adjust position.. Refer to assembly illustration.. |
| correctly on the handle? |
|
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
www.weber.com® 39
