ROTISSERIE BURNER TROUBLESHOOTING

WARNING: Before attempting any troubleshooting steps, all gas controls and supply valves should be in the OFF position.

Problem

Check

Cure

 

 

 

Burner does not light.

Did you hold the burner control

 

knob down and hold down for 10

 

seconds until after burner ignited?

Try to relight burner by holding burner control knob down and continue holding down until 10 seconds after burner has ignited.

Burner does not light or burner has a small flickering flame.

The excess flow safety device, which is part of the barbecue to cylinder connection, may have activated.

Too reset the excess flow safety device turn all burner control knobs and the cylinder valve OFF. Disconnect the regulator from the cylinder. Turn burner control knobs to HIGH. Wait at least 1 minute. Turn burner control knobs OFF. Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to “lighting instructions”

Burner does not light.

Is the igniter sparking

Replace battery in igniter

 

 

button module.

 

 

Reseat burner ring.

58

Page 58
Image 58
Weber Gas Burner manual Rotisserie Burner Troubleshooting, Problem Check Cure Burner does not light