21.Lubricate the 1/2” x 3 1/2” Bolt (96). Attach the Leg Press Arm (22) to the Press Base (3) with the Bolt and a 1/2” Nylon Locknut (95). Do not over- tighten the Nylon Locknut; the Leg Press Arm must be able to pivot easily.
Cable Assembly
22.Locate and open the parts bag labeled “CABLE ASSEMBLY.” For Cable identification and routing during steps 22 to 52, refer to the CABLE DIAGRAMS and CABLE ID CHART on page 26.
Do not overtighten the nylon locknuts attach- ing the pulleys to the weight system; the pul- leys must be able to turn freely.
Identify the Press Cable (80). It is approximately 387.25” long and it has a ball on one end and a loop on the other. Wrap the Press Cable around a 3 1/2” Pulley (37). Attach the Pulley to the Press Top Frame (13) with a 3/8” x 3 1/2” Bolt (65), a 3/8” Washer (75), and a 3/8” Nylon Locknut (74).
Be sure the Cable is between the Pulley and the rod on the Press Top Frame, and that the ball is on the side shown.
23.Loosen the 3/8” Nylon Locknut (not shown) on the 3/8” x 4” Bolt (91). Wrap the Press Cable (80) around the 3 1/2” Pulley (37), making sure the Cable is between the Pulley and the Cable Trap (44).
24.Wrap the Press Cable (80) around a 3 1/2” Pulley (37). Attach the Pulley to the indicated side of the Press Frame (14) with a 3/8” x 3 1/2” Bolt (65), a 3/8” Washer (75), and a 3/8” Nylon Locknut (74).
21 |
|
22 |
|
| 3 |
95 |
|
| Lubricate |
| 96 |
22 |
|
75 | 13 |
| |
74 |
|
Rod | 80 |
| 37 |
| 65 |
| Ball |
23 |
|
| 44 |
| 91 |
| 37 |
| 80 |
24 |
|
74 |
|
37 | 14 |
| 75 |
80 | 65 |
|
12
