38.Note: The 3 1/2Ó Pulley (82) used in this step was attached in step 36. It is shown removed for easier part identification.
Route the Press Cable (88) around the 3 1/2Ó Pulley (82). Make sure the Cable Trap (80) is turned to hold the Cable in place and that the Cable is rout- ed as shown. Tighten the 3/8Ó x 4 1/2Ó Bolt (74) and the 3/8Ó Nylon Jamnut (43).
39.Slide a 5/16Ó Washer (20) onto a 5/16Ó x 2 3/4Ó Bolt (55). Insert the Bolt into the Front Seat Frame (8). Fully tighten a 5/16Ó Nylon Jam Nut (91) onto the Bolt. Slide the end of the Press Cable (88) onto the Bolt. Thread another 5/16Ó Nylon Jam Nut (91) onto the Bolt, but do not fully tighten it. Leave enough room between the two Jam Nuts for the Cable to pivot.
40.Locate the High Cable (85)Ñthis is the longest remaining cable. Wrap the High Cable around a
3 1/2Ó Pulley (82). Attach the Pulley to the Top Frame
(2) with a 3/8Ó x 3 1/2Ó Bolt (66), a 3/8Ó Washer (38) and a 3/8Ó Nylon Jamnut (43). Make sure the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the post.
41.Wrap the High Cable (85) around a 3 1/2Ó Pulley (82). Attach the Pulley and a Cable Trap (80) to the Top Frame (2) with a 3/8Ó x 3 1/2Ó Bolt (66), a 3/8Ó Washer (38) and a 3/8Ó Nylon Jam Nut (43). Be sure that the
Cable Trap is positioned to hold the Cable in place.
38 |
|
|
|
|
|
|
|
| 43 |
|
|
|
| 82 |
|
|
|
| 80 |
|
|
|
| 88 |
|
|
| 74 |
|
39 |
|
|
|
|
|
|
| 8 | 88 |
|
|
|
| |
|
|
|
| 91 |
55 |
|
| 20 |
|
|
|
|
| |
40 |
|
|
|
|
38 |
| 2 |
|
|
|
|
|
| |
42 |
|
|
|
|
|
|
| 82 |
|
Post |
|
|
|
|
85 |
|
| 66 |
|
41 |
|
|
|
|
| 66 |
| 38 |
|
|
|
|
| |
|
| 2 |
| 80 |
|
|
|
| |
|
|
| 82 | 43 |
|
|
|
| |
|
|
|
| 85 |
17
