13.Attach the Leg Press Plate (11) to the Adjustment Tube (10) with a 5/16Ó x 2 1/2Ó Bolt (39), two 5/16Ó Washers (20) and a 5/16Ó Nylon Locknut (40). Make sure the Leg Press Plate and Adjustment Tube are oriented as shown.
Press a 1 3/4Ó Square Inner Cap (48) into the Adjustment Tube (10).
14.Attach the Adjustment Tube (10) to the Leg Press Arm (9) with the Lock Pin (73). Make sure the Leg
Press Plate (11) is oriented as shown.
Press two 2Ó Square Inner Caps (56) into the open ends of the Leg Press Arm (9).
ARM ASSEMBLY
15.Locate and open the parts bag labeled ÒARM ASSEMBLY.Ó
Attach the Leg Press Bumper (53) to the Front Seat Frame (8) with the 1Ó Tap Screw (72).
Lubricate the 3/8Ó x 3 1/4Ó Bolt (71). Attach the Leg Press Arm (9) to the Press Base (13) with the Bolt and a 3/8Ó Nylon Locknut (42).
16.Press a 1Ó x 7/8Ó Plastic Bushing (54) onto each welded spacer on the Press Frame (12). Slide the Press Frame onto the Press Base (13) so that the Plastic Bushings are aligned with the indicated tube.
Note: This will be a tight fit. Make sure that the high hole is on the side shown.
Lubricate the 3/8Ó x 8Ó Bolt (52). Attach the Press Frame (12) to the Press Base (13) with the Bolt and a 3/8Ó Nylon Locknut (42).
13 |
|
| 10 |
| 40 |
48 | 20 |
| |
39 |
|
| Angle |
| 11 |
14 | 10 |
73 |
|
| 11 |
| 9 |
| 56 |
15 |
|
| 8 |
| 9 |
| 53 |
| 42 |
| 72 |
| 71ÑLubricate |
| 13 |
16 |
|
| Tube |
High | 12 |
| |
Hole |
|
Welded | 13 |
| |
Spacers | 52ÑLubricate |
| |
42 | 54 |
|
9
