Weider WESY99300 Nylon Locknut, Butterfly Upright 62 in the same manner, Welded, Bracket, Wrap

15. Wrap the Short Cable (71) over a “V” Pulley (21) as		15
	shown. Attach the “V” Pulley and a Long Cable Trap
	(14) to one side of the welded bracket on the Butterfly
	Upright (62) with a 3/8” x 2 1/2” Bolt (6) and a 3/8”
	Nylon Locknut (4).		21
		6
	Wrap the Short Cable (71) over another “V” Pulley		14
			4	21
	(21), and attach the “V” Pulley and a Long Cable Trap
	(14) to the other side of the welded bracket on the	62		6
	Butterfly Upright (62) in the same manner.
		Welded
			14
		Bracket
		71
16.	Identify the Medium Cable (72). It has a ball on	16
	one end and a threaded shaft on the other.
		Wrap
	the Medium Cable over a 3 1/2” Pulley (5) as shown.
	Attach the Pulley to the Press Top Frame (63) with a	63		24
	3/8” x 3 1/2” Bolt (24), a 3/8” Flat Washer (17), and a
	3/8” Jam Nut (18).
			5
	Make sure that the Medium Cable (72) is between			72
	the 3 1/2” Pulley (5) and the welded pin on the
	Press Top Frame (63).			Pin
			17
		18
17.	Note: It may be helpful to loosen the indicated	17
	5/16” Nylon Locknuts (2) before beginning this		7
		5
	step.
		39
	Wrap the Medium Cable (72) over a 3 1/2” Pulley (5)			72
	as shown. Attach the Pulley and a Cable Trap (39) to	2
	the Press Top Frame (63) with a 3/8” x 3 3/4” Bolt (7).
				63
18. Route the threaded shaft on the Medium Cable (72)		18
	under one of the 3 1/2” Pulleys (5) that are already
	mounted in the Double “U”-Bracket (36). Tighten the
	3/8” x 1 3/4” Bolt (22).
				72
				5
				22
				36
		11