Weider WESY99300 user manual TROUBLE-SHOOTING and Maintenance, Ed, move the other Pulley

TROUBLE-SHOOTING AND MAINTENANCE

Inspect and tighten all parts each time you use the weight system. Replace any worn parts immediately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use sol- vents.

TIGHTENING THE CABLES

The type of cable used on weight systems can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. Slack can be removed from the cables in several differ- ent ways:

Moving one or both of the 3 1/2” Pulleys (5) to a different
set of holes in the Adjustable Pulley Plates (44) will tight-					35
en the cables.
To move one of the 3 1/2” Pulleys (5), remove the 3/8”				44
Nylon Locknut (4), 3/8” x 2” Bolt (35), Cable Trap (39),					Adjustment
and Pulley from the Adjustable Pulley Plates (44). Re-			4
					Holes
attach the Pulley and Cable Trap to the other hole in the					5
Pulley Plates.	Note: If additional adjustment is need-
ed, move the other Pulley.			39
Slack can be removed from the Long Cable (73) by relo-
cating the indicated 3 1/2” Pulley (5) on the Press Seat				52
Frame (52). To do this, remove the 3/8” Nylon Locknut
(4), 3/8” Flat Washer (17), and 3/8” x 2 1/2” Bolt (6). Re-		4
attach the Pulley at the second or third hole, as needed.
		17	14		5
					73
				6
The threaded shaft on the Medium Cable (72) attached to
the Weights (8) can also be used to tighten the cables.
To tighten the Medium Cable (72), remove the Small “U”-				72
				2
Bracket (43) by removing the 5/16” Nylon Locknut (2) and
					72
the 5/16” x 1 3/4” Bolt (9).				43
See the inset drawing. Tighten the 1/4” Nylon Locknut				9
(16) at the end of the Medium Cable (72) as far as it will					8
go. Then re-attach the Small “U”-Bracket (43).
					16
					43

If a cable slips off the pulleys often, the cable may have become twisted. Remove the cable and re-install it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

22