Weider WESY99300 user manual Arm Assembly, Locate and open the parts bag labelled “ARM, Assembly.”

Arm Assembly		9
9. Locate and open the parts bag labelled “ARM				53	30
ASSEMBLY.”						Lubricate
Press a 1” x 7/8” Plastic Bushing (29) onto each weld-			4
ed spacer on the Press Frame (53). Slide the Press
Frame onto the Press Base (60). (See the inset draw-					29
ing for proper orientation.)	Note: The Plastic					53
Bushings should fit onto the ends of the tube in
			Tube
the Press Base. This will be a tight fit.
			60
Lubricate the 3/8” x 8” Bolt (30). Attach the Press
Frame (53) to the Press Base (60) with the Bolt and a		10
3/8” Nylon Locknut (4).	Do not overtighten the Nylon				37
Locknut; the Press Frame must pivot easily.						80
10. Press a 1 3/4” Square Inner Cap (37) into the top of a
Press Arm (54). Press a 1” Inner Cap (80) into the
indicated hole in the Press Arm.			37
Attach the Press Arm (54) to the bracket on the Press
Frame (53) with two 5/16” x 2 1/2” Bolts (3) and two			80		54
5/16” Nylon Locknuts (2).
Repeat this step to assemble the second Press Arm
(54).				2
					3
					53
11. Press a 1 1/2” Square Inner Cap (79) into the Press		11
Seat Frame (52).
Slide the bracket on the lower end of the Press Seat					2
Frame (52) onto the indicated 5/16” x 2 1/2” Carriage			59		52
Bolts (1) in the Press Base (60). Tighten two 5/16”						79
Nylon Locknuts (2) onto the Bolts.
Attach the Press Seat Frame (52) to the Press Frame		20	19
Upright (59) with two 5/16” x 2 3/4” Bolts (20), two				2	2
5/16” Flat Washers (19), and two 5/16” Nylon
Locknuts (2).
			19
				1		60

9