Weider WESY99300 user manual Er Pulley will be attached to the Bolt

25.Note: For clarity, this and the following drawings show some parts removed.

Remove the lower 3 1/2” Pulley (5) from the Double “U”-Bracket (36). Wrap the Long Cable (73) over the Pulley in the direction shown. Attach the Pulley to the Double “U”-Bracket with a 3/8” x 1 3/4” Bolt (22) and

a 3/8” Nylon Locknut (4). Make sure that the Double “U”-Bracket is oriented as shown.

26.Wrap the Long Cable (73) around a 3 1/2” Pulley (5) in the direction shown. Attach the Pulley and a Cable Trap (39) to the indicated bracket on the Press Base

(60)with a 3/8” x 2” Bolt (35) and a 3/8” Nylon Locknut (4). Make sure that the Cable Trap is ori- ented as shown.

27.Wrap the Long Cable (73) around the 3 1/2” Pulley

(5)in the direction shown. Attach the Pulley and a Cable Trap (39) to the Press Frame Upright (59) with

a 3/8” x 4 3/4” Bolt (23). Hand tighten a 3/8” Nylon Locknut (4) two turns onto the Bolt. In step 31, anoth-

er Pulley will be attached to the Bolt.

28.Wrap the Long Cable (73) around a 3 1/2” Pulley (5) in the direction shown. Attach the Pulley and a Cable Trap (39) to the indicated hole in the Press Frame

(53)with a 3/8” x 3 1/4” Bolt (28), a 3/8” Flat Washer

(17), and a 3/8” Nylon Locknut (4). Make sure that

the Pulley is mounted on the inside of the Press Frame and that the Cable Trap is oriented as shown.

25
36		4
22
		5
		73
26	73
	5	35
39
4
	60
27
		59
			73
		5	23
			39
4
28
73	53	17	28
	39
4	5

14