Weider WESY99300 Locate and open the parts bag labelled Frame Assembly, Head of each Bolt

Frame Assembly

1.Before beginning, make sure that you have read and understood the information on page 5.

Locate and open the parts bag labelled “FRAME ASSEMBLY.”

Press a 2” Square Inner Cap (38) into the Butterfly Base (61). Press two 2” Square Inner Caps into the Press Base (60).

Insert four 5/16” x 2 1/2” Carriage Bolts (1) up through the indicated holes in the Butterfly Base (61)

and the Press Base (60).	Note: If the Bolts fall out,
secure them by putting a small piece of tape over
the head of each Bolt.	Place the Butterfly Base and
the Press Base flat on the floor.

Attach the Press Base (60) to the Butterfly Base (61) with two 5/16” x 2 3/4” Bolts (20), two 5/16” Flat Washers (19), and two 5/16” Nylon Locknuts (2).

2.Position the Butterfly Upright (62) as shown. Place the bracket on the lower end of the Butterfly Upright

over the indicated 5/16” x 2 1/2” Carriage Bolts (1) in the Butterfly Base (61). Hand tighten two 5/16” Nylon

Locknuts (2) onto the Bolts.	Do not tighten the
Nylon Locknuts yet.
Place the bracket on the lower end of the Press
Frame Upright (59) over the indicated 5/16” x 2 1/2”
Carriage Bolts (1) in the Press Base (60). Hand tight-
en two 5/16” Nylon Locknuts (2) onto the Bolts.		Do
not tighten the Nylon Locknuts yet.

1
	38
	19
2	20
61	60
	38
	2
1	1
	1
1
38
2

Position with the bracket on this side

62 59

2

2

1

1

61 60

6