29.Wrap the Long Cable (73) around a “V” Pulley (21) in the direction shown. Attach the “V” Pulley and a Long Cable Trap (14) to the small tube on the Press Seat
Frame (52) with a 3/8” x 3 1/4” Bolt (28), a 3/8” Flat
Washer (17), and a 3/8” Nylon Locknut (4). | Note: The |
small tube has three adjustment holes. Mount the |
|
“V” Pulley in the hole farthest from the Press |
|
Frame Upright (59). Make sure that the Cable Trap |
|
is oriented as shown. |
|
30.Wrap the Long Cable (73) around a 3 1/2” Pulley (5) in the direction shown. Attach the Pulley and a Cable Trap (39) to the indicated hole in the Press Frame
(53)with a 3/8” x 3 1/4” Bolt (28), a 3/8” Flat Washer
(17), and a 3/8” Nylon Locknut (4). Make sure that
the Pulley is mounted on the inside of the Press Frame and that the Cable Trap is oriented as shown.
31.Route the Long Cable (73) around a 3 1/2” Pulley (5) and back through the opening in the Press Frame (53).
Remove the 3/8” Nylon Locknut (4) from the 3/8” x |
|
4 3/4” Bolt (23) that was inserted in step 27. Attach |
|
the Pulley and a Cable Trap (39) to the Bolt and |
|
secure them with the Nylon Locknut. | Make sure that |
the Cable Trap is oriented as shown. |
|
32.Note: Lift the Top Weight (78) on the weight stack in order to create slack in the Long Cable (73) before beginning this step.
Attach the Long Cable (73) to the Leg Lever (49) by slipping the looped end of the Cable onto the looped end of the 3/8” x 2 1/2” Eyebolt (83).
29 |
| 59 |
|
|
| 52 |
|
|
| 4 |
|
|
| 17 |
|
|
| 14 |
|
|
| 21 |
|
|
| 28 |
|
|
| 73 |
|
30 |
|
|
|
|
| 73 |
|
|
| 4 |
|
17 |
|
|
|
28 |
| 5 |
|
|
| 39 |
|
| 53 |
|
|
31 |
|
|
|
| 39 |
|
|
|
| 53 |
|
| 5 | 23 |
|
|
|
| |
4 |
| 73 |
|
|
|
| |
32 |
|
|
|
|
| 83 | 49 |
|
| 73 |
|
15
