Weider XE-A101 instruction manual Maintenance, Drawer Handling, Replacing the Paper Roll

Maintenance

Drawer Handling

Locking the Drawer

Develop the habit of locking the drawer when not using the register for any extended period of time.

To lock the drawer, turn 90 degrees counter-clockwise, and to unlock the drawer, turn 90 degrees clockwise.

Removing the Drawer

To detach the drawer, pull it forward fully, and remove it by lifting it up. The 5-denomination coin case is detachable from the till.

Manually Opening the Drawer

In case of a power failure or if the machine is out of order, slide the lever located on the machine bottom toward the direction of the arrow to open the drawer manually. The drawer will not open if it is locked with a drawer lock key, though.

Replacing the Paper Roll

When a dye appears on the paper roll, it is time to replace the paper roll with new one. Be sure to use the paper roll specified in “Specification” section.

In case of journal printing

1.Set the mode switch to the REG position.

2.Remove the printer cover.

3.Press o to advance the paper by several lines and then cut it to remove the take-up spool from the bearing.

4.After cutting the existing paper, remove the paper roll. Then remove the remaining paper by pressing o.

5.Remove the paper roll from the take-up spool.

6.Install a new paper roll and replace the take-up spool according to the instructions on page 5.

In case of receipt printing, do the above steps 1, 2, 4 in this order and then install a new paper roll according to the instructions on page 5.

22