Western Telematic MT5634 manual Command Ds Dial, Command DS=y Dial Stored Telephone Number

MT5634 Modem; AT Command Set

Command: Ds	Dial
Values:	s = dial string (phone number and dial modifiers)
Default:	none
Description:	Dial telephone number s, where s may up to 40 characters long
	and include the 0–9, *, #, , B, C, and D characters, and the L, P, T,
	V, W, S, comma (,), semicolon (;), !, @, ^ and $ dial string
	modifiers.
	Dial string modifiers:
	L	Redial last number. (Must be placed immediately
	P	after ATD.)
		Pulse-dial following numbers in command.
	T	Tone-dial following numbers in command (default).
	V	Switch to speakerphone mode and dial the following
	W	number. Use ATH command to hang up.
		Wait for a new dial tone before continuing to dial.
	,	(X2, X4, X5, X6, or X7 must be selected.)
		Pause during dialing for time set in register S8.
	;	Return to command mode after dialing. (Place at end
	!	of dial string.)
		Hook flash. Causes the modem to go on-hook for
	@	one-half second, then off-hook again.
		Wait for quiet answer. Causes modem to wait for a
		ringback, then 5 seconds of silence, before
		processing next part of command. If silence is not
	^	detected, the modem returns a NO ANSWER code.
		Disable data calling tone transmission.
	$	Detect AT&T call card “bong” tone. The character should
		follow the phone number and precede the user’s call card
		number: ATDT1028806127853500$123456789
Command: DS=y Dial Stored Telephone Number
Values:	y = 0–2 (0–1 for SMI-Parallel {internal})
Default:	none
Description:	Dial a number previously stored in directory number y by the
	&Zy=x command. Example: ATDS=2

Command: En	Echo Command Mode Characters
Values:	n = 0 or 1
Default:	1
Description:	E0	Do not echo keyboard input to the terminal.
	E1	Do echo keyboard input to the terminal.

Command: Fn	Echo Online Data Characters
Values:	n = 1
Default:	1
	F0	Enable online data character echo. (Not supported.)
	F1	Disable online data character echo (included for
		backward compatibility with some software).

3-2