White Rodgers 1F92W-51 manual the wall. Then press, tem operation, and press, to begin the, Mostat

the wall. Then press	SYSTEM		for desired sys-
	HEAT-OFF-COOL-AUTO
tem operation, and press		RUN		to begin the
		PRGM

factory preset program. Or you may re-program the thermostat, then replace it on the wall.

To prevent further static discharge problems, touch another object to release static build-up before touching the thermostat. See OPERAT-

ING YOUR THERMOSTAT.

7.Why won’t the setpoint temperature go to the temperature I want?

In the AUTO mode, the highest heating setpoint temperature you select must be at least 1°F

lower than the lowest cooling setpoint tempera- ture you select (for example, if 70°F is your lowest selected cooling temperature, you cannot

select a heating temperature any higher than 69°F). If such a conflict exists, you must set the lowest cooling temperature higher in order to set

the heating temperature higher. To set a lower cooling temperature, you must select a lower heating temperature. See PROGRAMMING YOUR THERMOSTAT.

8.The display is flashing BAT. What does this mean?

The 9 volt battery installed in the thermostat is low and should be replaced with a fresh 9 volt Energizer® alkaline battery. See OPERATING YOUR THERMOSTAT.

9.The display shows a continuous (non-flash- ing) BAT. What does this mean?

The thermostat is not being supplied with 24 VAC power. The thermostat is operating on battery power alone. See OPERATING YOUR THER-

MOSTAT.

46