Winegard WB-2700, WB-2000 operation manual Factory Default, Sleep Menu, Enter Sleep, Mode

Factory Default

If you determine that your satellite antenna is not functioning as expected, you may want to return your system to factory default and run the satellite setup again.

From the Main Menu, press [ENTER] to confirm Satellite Setup.

Press [SELECT] 2 times to select Factory Default.

Satellite Interface

POWER	Factory Default*	SELECT	ENTER
	Exit

Press [ENTER] to confirm.

A confirmation will appear. Press [SELECT] to select Yes, then press [ENTER] to con- firm. A confirmation message will appear, and the Satellite Interface will reset. You should now repeat satellite setup.

7.3 Sleep Menu

The Sleep Menu is applicable for in-motion systems only. The Sleep Menu will have no effect on stationary only systems.

An in-motion satellite system has two modes, Tracking Mode and Sleep Mode. In Track- ing Mode, the satellite antenna is actively following the satellite. If the antenna senses RV movement, it will move along with the RV. The antenna will automatically enter Sleep Mode if it does not sense movement in the RV for 7 minutes. In sleep mode, the antenna remains motionless on the satellite signal.

Sleep Menu options flow in the following order:

Enter Sleep → Exit Sleep Mode → Set Sleep Time → Default Sleep → Exit

From the Main Menu, press [SELECT] to select Sleep Menu.

Satellite Interface

POWER	Sleep Menu*	SELECT	ENTER
	Diagnostics

Press [ENTER] to confirm.

Enter Sleep

You may force the antenna into Sleep Mode at any time while the system is in Tracking

Mode.

From the Sleep Menu, press [ENTER] to confirm Enter Sleep.

Satellite Interface

POWER	Sleep Menu*	SELECT	ENTER
	Exit Sleep Mode

A confirmation message will appear. The antenna will immediately exit Tracking Mode and enter Sleep Mode.

27