To reset the Satellite Receiver, press and hold the Power button on the Receiver (not on the remote control). The receiver will reset, and after a few moments will automatically restart. It may take up to 5 minutes for some receivers to restart.
After the receiver reboots, the new Guide will download, and the programming on the new satellite will be available. You must repeat this process each time you manually change satellites for Dish Network or Bell ExpressVU.
Returning to Automatic Mode
The antenna will remain in Manual Mode until a Service Provider is chosen to put the antenna back into Automatic Mode. See the operating section for your service provider for instructions on choosing your service provider.
To Operate in Manual Mode
From the Main Menu, press [ENTER] to confirm Satellite Setup.
Satellite Interface
POWER |
|
| Satellite Setup* | SELECT |
| ENTER |
|
| Sleep Menu |
| |||
|
|
|
|
|
|
Press [SELECT] to select Manual Mode.
Satellite Interface
POWER |
|
| Manual Mode* | SELECT |
| ENTER |
|
| Factory Default |
| |||
|
|
|
|
|
|
Press [ENTER] to confirm.
Press [SELECT] to cycle through the available satellites.
Satellite Interface
POWER |
|
| Sat: 61.5 |
|
| 72.5 | |
|
|
|
SELECT ENTER
When you have selected your desired satellite, press [ENTER]. A Confirmation screen will appear, and you will be prompted to Save Changes.
Press [SELECT] to select YES.
Press [ENTER] to confirm.
The Satellite Interface will reset, and the satellite antenna will begin its search routine for the selected satellite. After acquisition, you will be able to watch television on the selected satellite.
26
