FG_FoodProc Manual2 7/7/06 3:54 PM Page 23
Care and Cleaning
Ensure that your food processor is unplugged from the electrical outlet before cleaning.
Wipe the base and cord with a warm soapy cloth and wipe clean with a damp cloth. Dry thoroughly. Do not use any abrasive cleaners or scouring pads on the housing as this will damage the finish. Wash the processing bowl, cover and all attachments (except motor base) in warm water using a mild detergent (or see dishwasher instructions below). Dry each part thoroughly before use.
Warning: Care must be taken when handling the metal blades as these items are extremely sharp.
Dishwasher Use
All plastic components deteriorate through the prolonged use of a dishwasher for cleaning. However all parts of your Food Processor are tolerant to dishwasher use, (excluding the processor body). If using the dishwasher place parts only on the top rack of your dishwasher.
Once your food processor and accessories have been cleaned and dried thoroughly, store your food processor as outlined in the section “Storing your Food Processor.”
Fitting the Continuous
Flow Attachment
(Sold separately)
Before Using the Continuous Flow Attachment
Wash the processing bowl with chute, ejector disc and food collector in warm water using a mild detergent. dry each part thoroughly before use. Before you assemble your Food Processor, ensure that the power cord is unplugged.
1Place the motor base facing you on a dry, level surface.
2Place the processing bowl onto the motor base, the bowl will only sit correctly on the base when the handle is positioned to the right, see figure 1.
3Rotate the handle clockwise to lock as indicated by the graphics on the left side of the motorbase, see figure 2.
4Fit the spindle onto the drive shaft.
5Fit the ejector disc over the spindle.
6Fit the required disc for processing above the ejector disc on the spindle.
7Position the lid onto the processing
bowl, ensuring that the lid locks into place, following lock directions on lid, see figures 7 and 8.
8Fit the Food Collector underneath the processing bowl chute. The Food Collector should fit alongside the food processor and the opening of bowl should be in line with the chute. See figure 21 for the properly assembled unit.
figure 20 | figure 21 |
21 | 22 |
