Woods Equipment LU126 Hydraulic Installation, Hose Kit, General Description, Assemble Hoses

1023584 HOSE KIT

General Description

These set-up instructions are for operating the LU126 or LU132 loader using the tractor hydraulics. To use this connection, the tractor must be equipped with two hydraulic levers and four tractor hydraulic couplers at the rear of the tractor as shown in Figure 38.

NOTE: The male hydraulic quick couplers for connec- tion to tractor are NOT INCLUDED with this hose kit but are available as service parts.

NOTE: After the hydraulics and loader are installed on the tractor, check the clearance between the top of the exhaust pipe and the loader boom when the loader is raised. If there is interference, a weather cap will need to be installed. See Page 6 for installation instructions.

DP12

Figure 38. Tractor Rear Hydraulic Couplers (Typical)

Assemble Hoses

1.Attach a 90-degree elbow (2) and male quick coupler (3) to each loader supply hose (1). See Figure 39.

2.Connect loader supply hoses to loader feedlines as shown in Figure 40.

3.Route hoses along right mount, under the cab/operator’s platform, and over right rear axle. Be sure to avoid contact with 3-point linkage, brake pedals, and other moveable tractor components. Hoses must be routed so that they are not pinched, bent sharply, or chafed during operation.

1.1023493 Hose, 200" x 3/4 JICM x 3/4 JICM

2.313053 Elbow, 3/4 JICF x 1/2 NPTM 90°

3.	-------- Quick coupler, male	Figure 39. Hose Assembly
	(not included in kit)

Figure 40. Loader Feedline Connections

22 Hydraulic Installation MAN0041 (Rev. 4/4/2008)