Recommended Adjustments, Tighten V-Belts | Woodstock W1754 specs

W1754 20" Planer With Mobile Base

SET UP

Recommended

Adjustments

For your convenience, the adjustments listed below have been performed at the factory and no further setup is required to operate your machine.

However, because of the many variables involved with shipping and storage, some of these adjustments may need to be repeated to ensure optimum cutting results. Keep this in mind as you start to use your new planer.

Step-by-step instructions for these adjustments can be found in the SERVICE section.

1.Table Parallelism (Page 29).

2.Chain Tension (Page 28).

3.Spring Tension (Page 34).

4.Rollers, Chip Breakers and Pressure Bar Heights (Page 31).

5.Chip Deflector Positioning (Page 35).

Loose hair and clothing could get caught in machinery and cause serious personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.

Tighten V-Belts

The final step in the setup process must be done after approximately 16 hours of operation. During this first 16 hours, the V-belts will stretch and seat into the pulley grooves. After this 16 hours, the V-belts must be ten- sioned or your belts will slip and burn out. Refer to Page 24 when you are ready to perform this important adjust- ment.

Note: Pulleys and belts run very hot. This is a normal condition. Allow them to cool before making adjustments.

Note: A collection of black belt dust at the bottom of the belt housing is a normal during the life of the machine and does not indicate premature belt failure is in prog- ress.

-16-

Image 18

Woodstock W1754 owner manual Recommended Adjustments, Tighten V-Belts

Contents

Planer with Mobile Base Page Contents Introduction Woodstock Technical Support Introduction Controls and Features Safety Standard Safety Instructions Always Lock Mobile Bases Before Operating Machinery Additional Safety Instructions for Planers Electrical Specifications Electrical220V Operation Unpacking SetupItems Needed for Setup Inventory Machine Placement Lifting PlanerHardware and Tools Not Shown Cleaning Machine These items are coated and must be cleaned Extension Wings Extension wing fasteners Leveling controls To install the handwheel, do these steps To install the caster and foot pedal, do these stepsHandwheel, Dust Hood Caster Connecting to Power Gearbox Oil LevelTo check the gearbox oil level, do these steps Test Run To perform a test run, do these steps Recommended Adjustments Tighten V-Belts Basic Operation OperationsGeneral Basic steps of operating the planer are as follows Operation Tips Feed Speed Feed control knob positions Adjustment Height Range 002-0.020 To adjust the bed rollers, do these stepsBed Rollers Accessories Planer Accessories Operations Maintenance CleaningMaintenance Schedule To adjust/replace the V-belts, do these steps BeltsPulley Alignment on Lubrication Service Inspecting KnivesTo inspect the knives, do these steps Setting/Replacing Knives To set the knives, do these steps To adjust the chain tension, do these steps Chain Tension Table Parallelism Maximum Allowable Tolerances To adjust the table parallelism, do these steps Table micro-adjustment screws Rollers, Breaker Pressure Bar Heights Distance Below Knife Edge at *BDC Location Service To adjust roller spring tension, do these steps Spring Tension Scale Calibration Loosen the chip deflector mounting bolts see FigureTo calibrate the scale, do these steps Anti-Kickback Fingers Anti-kickback fingers Pulley Alignment Example of checking belt Alignment W1754 Electrical Components Motor junction box W1754 20 Planer With Mobile Base Troubleshooting Problem Possible Cause Corrective Action Cutting Headstock Assembly Parts Breakdown Headstock Assembly Parts List PART# Description Cutterheadpulley Gearbox Parts Breakdown Gearbox Parts List Base Breakdown Base Parts List Table Breakdown & List Columns Breakdown Columns Parts List Labels & Cosmetic Parts Warranty Page Warranty Registration Comments BOX BELLINGHAM, WA