Gearbox Parts Breakdown | Woodstock W1754 specification

W1754 20" Planer With Mobile Base

Gearbox Parts Breakdown

��

��

��

��

��

��

��

��

��

��

��

��

��

��

��

	��	��
	��
	��
��	��
��	��
��	��
��
��
		��
		��
		��
��		��
��		��
		��
		��
		��

��

��

��

��

��

PARTS

-45-

Image 47

Woodstock W1754 owner manual Gearbox Parts Breakdown

Contents

Planer with Mobile Base Page Contents Woodstock Technical Support Introduction Introduction Controls and Features Standard Safety Instructions Safety Always Lock Mobile Bases Before Operating Machinery Additional Safety Instructions for Planers 220V Operation Electrical SpecificationsElectrical Inventory SetupItems Needed for Setup Unpacking Hardware and Tools Not Shown Machine PlacementLifting Planer These items are coated and must be cleaned Cleaning Machine Extension wing fasteners Leveling controls Extension Wings Handwheel, Dust Hood Caster To install the handwheel, do these stepsTo install the caster and foot pedal, do these steps To check the gearbox oil level, do these steps Connecting to PowerGearbox Oil Level To perform a test run, do these steps Test Run Tighten V-Belts Recommended Adjustments Basic steps of operating the planer are as follows OperationsGeneral Basic Operation Operation Tips Feed control knob positions Feed Speed Bed Rollers Adjustment Height Range 002-0.020To adjust the bed rollers, do these steps Planer Accessories Accessories Operations Maintenance Schedule MaintenanceCleaning Pulley Alignment on To adjust/replace the V-belts, do these stepsBelts Lubrication To inspect the knives, do these steps ServiceInspecting Knives To set the knives, do these steps Setting/Replacing Knives Chain Tension To adjust the chain tension, do these steps Maximum Allowable Tolerances Table Parallelism Table micro-adjustment screws To adjust the table parallelism, do these steps Distance Below Knife Edge at *BDC Rollers, Breaker Pressure Bar Heights Location Service Spring Tension To adjust roller spring tension, do these steps To calibrate the scale, do these steps Scale CalibrationLoosen the chip deflector mounting bolts see Figure Anti-kickback fingers Anti-Kickback Fingers Example of checking belt Alignment Pulley Alignment Motor junction box W1754 Electrical Components W1754 20 Planer With Mobile Base Problem Possible Cause Corrective Action Troubleshooting Cutting Headstock Assembly Parts Breakdown PART# Description Headstock Assembly Parts List Cutterheadpulley Gearbox Parts Breakdown Gearbox Parts List Base Breakdown Base Parts List Table Breakdown & List Columns Breakdown Columns Parts List Labels & Cosmetic Parts Warranty Page Comments Warranty Registration BOX BELLINGHAM, WA