X10 Wireless Technology XX34A user manual Default Parameters, Problems with network bandwidth

4.1.13There’s no picture (Problems with ActiveX Controller)

If using IE browser to connect the camera for the first time, and there is no image displayed, you might need to install ActiveX. You need to change some browser settings to enable ActiveX. (See: For IE Browser).

4.1.14Problems with network bandwidth

The image frame rate is subject to the following factors:

1.Network bandwidth.

2.PC performance, network environment and display preference setting (brightness, theme, etc).

3.The number of visitors (too many visitors will slow down the image frame rate).

4.Choice of switch or hub (use a switch for multiple IP Camera Servers rather than a HUB).

4.1.15How to register an account from DDNS web

You can enter http://www.dyndns.com and register an account.

4.1.16Pop-up the prompt” Fail to connect to the device…”?

This prompt only appears in the case of using multiple cameras.

When you set multiple cameras, and the device status light changes to yellow please make sure the cameras are connected to power and working correctly.

4.2Default Parameters

Default network Parameters

IP address: dynamic

Subnet mask: dynamic

Gateway: dynamic

DHCP: Disabled

DDNS: factory DDNS and third party DDNS

Username and password

Default administrator username: admin

Default administrator password: None, i.e., leave blank.

56