Features and Specifications | Xantrex Technology GPIB-XPD specs

Section 1. Features and Specifications

Description

The internal GPIB interface card allows you to operate your power supply from a computer controller via the IEEE-488 communications bus. See Figure 1.1, “Sample Configuration using GPIB Interface”.

The GPIB interface allows complete remote programming of your power supply, including status reporting, settings query, and interrupt generation with user-designated fault conditions. Both the voltage and current output are precisely programmed directly in volts and amps with 16-bit resolution. Additionally, the built-in DVM and current shunt measure the actual power supply output and provide you with 16-bit readback. The programming command set is easy-to-use and includes software calibration commands. The interface card comes standard with several protection features such as programmable over voltage protection, foldback, load isolation signal, and soft limits.

Figure 1.1	Sample Configuration using GPIB Interface
Release 1.2	11

Image 13

Xantrex Technology GPIB-XPD manual Features and Specifications, Description

Contents

GPIB-XPD Page Internal Gpib Interface for XPD 500 Watt Series Phone 604 422 Toll Free North America 800 667 Fax 604 421 How do you get service? What does this warranty not cover? Disclaimer Product Model Number Serial Number Purchased From Purchase Date Information About Your Power Supply Supply Safety Main Sections Installation and ConfigurationManual Revisions About This Manual Contents Contents Description Features and Specifications Features and Specifications Features and FunctionsFunctions Readback Models 18-30 33-16 60-9 120-4.5 SpecificationsOVP Features and Specifications Initial Inspection Introduction Power Supply Front Panel with Gpib Interface Installed Gpib Interface Subplate Located on Power Supply Rear Panel Gpib Interface PCB Step # Description Action Reference Basic Setup ProcedurePON SRQ Address IEEE-488 Primary Address Selection Rear Panel SRQ Switch Position PON SRQ State Power On Service Request PON SRQSwitch Position Power on results Iset Condition Default Settings Model Example Internal PCB Jumper Selections IEEE-488 Controller Connection OVP Control Mode Selection High OFF LOW User SignalsHigh LOW OFF User Signals J21 Connector J21 User Signal Connector Circuit Block Diagram J21 User Cable with Ferrite Block Gpib Operation Operation Example Command directed to entire bus, or Request Service SRQ Set when Bit Decimal Description Reset By Position WeightPower On PON Set when unit LSB Computer Entry Command SyntaxFormat Floating Number Definition Example Description Form Iset 2.0A Vset Command Summary AUXB? AUXA?CMODE? DLY? Cmode FAULT?Idata IHI Command Description Command ReferenceAuxa 1 on Auxb 1 on Changing an output setting Response Fold mode where mode is Mask None = Unmask ALL Snsp Status, and Fault Registers on SNSP, ALL, None Accumulated Status, Status, and Fault Registers on Response Vmax voltage Condition Mnemonic Bit Position Bit Weight Accumulated Status, Status, and Fault Registers 11 Error Codes Error Codes LEDs Troubleshooting Calibration Setup Voltage Mode CalibrationVoltage Program Calibration Procedure Readback Voltage Calibration Current Calibration Setup Current Mode CalibrationCurrent Program Calibration Procedure Current Readback Calibration Procedure Over Voltage Protection OVP Calibration Page Xantrex Technology Inc