Gpib Interface PCB | Xantrex Technology GPIB-XPD manual

Installation and Configuration

Initial Inspection

	JUMPER SELECTION
J2	Local OVP control selection	[closed] [default]. See page 23.
		[open] Front Panel OVP Control.
J3	User TTL shutdown (S/D) selection	[1-2] User TTL S/D line active low.
		See page 27.
		[2-3] [default] User TTL S/D line active high.
J20	Remote OVP Control Selection	[closed] [default]. See page 23.
		[open]

Note: All other jumpers are not user-selectable.

		LED INDICATORS
D1	Red Diagnostic LED	Bus error or soft restart on Slave circuitry.
D4	Red Diagnostic LED	Soft restart on Master circuitry.
D5	Green Diagnostic LED	Bus error on Master circuitry.
		See page 48.

		EPROMS
U18	Slave EPROM	See revision number stamped on EPROM.
U1	Master EPROM	See revision number stamped on EPROM.

Figure 2.3 GPIB Interface PCB

18	Operating Manual for GPIB for XPD Series Power Supply

Image 20

Xantrex Technology GPIB-XPD manual Gpib Interface PCB

Contents

GPIB-XPD Page Internal Gpib Interface for XPD 500 Watt Series How do you get service? Phone 604 422 Toll Free North America 800 667 Fax 604 421 What does this warranty not cover? Disclaimer Product Information About Your Power Supply Model Number Serial Number Purchased From Purchase Date Safety Supply Manual Revisions Installation and ConfigurationMain Sections About This Manual Contents Contents Features and Specifications Description Features and Functions Features and SpecificationsFunctions Readback OVP SpecificationsModels 18-30 33-16 60-9 120-4.5 Features and Specifications Introduction Initial Inspection Power Supply Front Panel with Gpib Interface Installed Gpib Interface Subplate Located on Power Supply Rear Panel Gpib Interface PCB PON SRQ Basic Setup ProcedureStep # Description Action Reference IEEE-488 Primary Address Selection Address Switch Position Power on results Power On Service Request PON SRQRear Panel SRQ Switch Position PON SRQ State Condition Default Settings Model Example Iset IEEE-488 Controller Connection Internal PCB Jumper Selections OVP Control Mode Selection High LOW OFF User SignalsHigh OFF LOW User Signals J21 Connector J21 User Signal Connector Circuit Block Diagram J21 User Cable with Ferrite Block Operation Gpib Operation Example Command directed to entire bus, or Bit Decimal Description Reset By Position Weight Request Service SRQ Set whenPower On PON Set when unit LSB Format Command SyntaxComputer Entry Description Form Floating Number Definition Example Iset 2.0A Vset Command Summary AUXA? AUXB?CMODE? DLY? FAULT? CmodeIdata IHI Command Reference Command DescriptionAuxa 1 on Auxb 1 on Changing an output setting Response Fold mode where mode is Snsp Mask None = Unmask ALL Status, and Fault Registers on Accumulated Status, Status, and Fault Registers on SNSP, ALL, None Response Vmax voltage Accumulated Status, Status, and Fault Registers Condition Mnemonic Bit Position Bit Weight Error Codes 11 Error Codes Troubleshooting LEDs Calibration Voltage Mode Calibration SetupVoltage Program Calibration Procedure Readback Voltage Calibration Current Program Calibration Procedure Current Mode CalibrationCurrent Calibration Setup Current Readback Calibration Procedure Over Voltage Protection OVP Calibration Page Xantrex Technology Inc