Safety, Supply | Xantrex Technology GPIB-XPD specs

Power

Supply		WARNING—High Energy and High Voltage
Safety		Exercise caution when using and calibrating a power supply. High energy levels
		can be stored at the output voltage terminals on a power supply in normal
		operation. In addition, potentially lethal voltages exist in the power circuit and on
		the output and sense connectors of a power supply with a rated output greater
		than 40 V. Filter capacitors store potentially dangerous energy for some time
		after power is removed.


		CAUTION
		CAUTION
		Operate the power supply in an environment free of flammable gases or fumes.
		To ensure that the power supply’s safety features are not compromised, use the
		power supply as specified in this manual and do not substitute parts or make any
		unauthorized modifications. Contact the service technician for service and repair
		help. Repairs must be made by experienced service technicians only.

Warnings,

Cautions,

and Notes

Warnings, cautions, and notes are defined and formatted in this manual as shown below.

WARNING

Describes a potential hazard which could result in injury or death, or, a procedure which, if not performed correctly, could result in injury or death.

CAUTION

Describes a procedure which, if not performed correctly, could result in damage to data, equipment, or systems.

Note

Describes additional operating information which may affect the performance of the equipment.

vi	Operating Manual for GPIB for XPD Series Power Supply

Image 8

Xantrex Technology GPIB-XPD manual Safety, Supply

Contents

GPIB-XPD Page Internal Gpib Interface for XPD 500 Watt Series How do you get service? Phone 604 422 Toll Free North America 800 667 Fax 604 421 What does this warranty not cover? Disclaimer Product Information About Your Power Supply Model Number Serial Number Purchased From Purchase Date Safety Supply Manual Revisions Installation and ConfigurationMain Sections About This Manual Contents Contents Features and Specifications Description Features and Functions Features and SpecificationsFunctions Readback OVP SpecificationsModels 18-30 33-16 60-9 120-4.5 Features and Specifications Introduction Initial Inspection Power Supply Front Panel with Gpib Interface Installed Gpib Interface Subplate Located on Power Supply Rear Panel Gpib Interface PCB PON SRQ Basic Setup ProcedureStep # Description Action Reference IEEE-488 Primary Address Selection Address Switch Position Power on results Power On Service Request PON SRQRear Panel SRQ Switch Position PON SRQ State Condition Default Settings Model Example Iset IEEE-488 Controller Connection Internal PCB Jumper Selections OVP Control Mode Selection High LOW OFF User SignalsHigh OFF LOW User Signals J21 Connector J21 User Signal Connector Circuit Block Diagram J21 User Cable with Ferrite Block Operation Gpib Operation Example Command directed to entire bus, or Bit Decimal Description Reset By Position Weight Request Service SRQ Set whenPower On PON Set when unit LSB Format Command SyntaxComputer Entry Description Form Floating Number Definition Example Iset 2.0A Vset Command Summary AUXA? AUXB?CMODE? DLY? FAULT? CmodeIdata IHI Command Reference Command DescriptionAuxa 1 on Auxb 1 on Changing an output setting Response Fold mode where mode is Snsp Mask None = Unmask ALL Status, and Fault Registers on Accumulated Status, Status, and Fault Registers on SNSP, ALL, None Response Vmax voltage Accumulated Status, Status, and Fault Registers Condition Mnemonic Bit Position Bit Weight Error Codes 11 Error Codes Troubleshooting LEDs Calibration Voltage Mode Calibration SetupVoltage Program Calibration Procedure Readback Voltage Calibration Current Program Calibration Procedure Current Mode CalibrationCurrent Calibration Setup Current Readback Calibration Procedure Over Voltage Protection OVP Calibration Page Xantrex Technology Inc