Emergency Power Off
If any of the following conditions occur, turn off the machine immediately and disconnect the power cable(s) from the electrical outlet(s). Contact an authorized Xerox Service Representative to correct the problem:
•The equipment emits unusual odors or makes unusual noises.
•The power cable is damaged or frayed.
•A wall panel circuit breaker, fuse, or other safety device has been tripped.
•Liquid is spilled into the machine.
•The machine is exposed to water.
•Any part of the machine is damaged.
Ozone Information
This product produces ozone during normal operation. The ozone produced is heavier than air and is dependent on copy volume. Install the system in a
If you need additional information about ozone, please request the Xerox publication Facts About Ozone (part number 610P64653) by calling
Maintenance Information
1Any operator product maintenance procedures will be described in the customer documentation supplied with the product.
2Do not carry out any maintenance on this product which is not described in the customer documentation.
3Do not use aerosol cleaners. The use of cleaners that are not approved may cause poor performance of the equipment, and could cause a dangerous condition.
4Use supplies and cleaning materials only as directed in this manual.
5Do not remove covers or guards that are fastened with screws. There are no parts behind these covers that you can maintain or service.
6Do not perform any maintenance procedures unless you have been trained to do them by an authorized local dealer or unless a procedure is specifically described in the user manuals.
Consumables Information
1Store all consumables in accordance with the instructions given on the package or container.
2Keep all consumables away from the reach of children.
3Never throw toner, print cartridges or toner containers into an open flame.
Product Safety Certification
This product is certified by the following Agency using the Safety standards listed;
Agency | Standard |
|
|
Underwriters | |
Laboratory Inc. | Canada) |
|
|
Intertek ETL | |
Semko |
|
|
|
Regulatory Information
Certification in Europe
CE The CE mark applied to this product, symbolizes XEROX's declaration of conformity with the following applicable European Union Directives, as of the dates indicated:
December 12, 2006: Council Directive 2006/95/EC as amended. Approximation of the laws of the member states related to low voltage equipment.
December 15, 2004: Council Directive 2004/108/EC as amended. Approximation of the laws of the member states related to electromagnetic compatibility.
A full declaration of conformity, defining the relevant directives and referenced standards, can be obtained from your XEROX Limited representative or by contacting:
Environment, Heath and Safety
Xerox Limited
Bessemer Road
Welwyn Garden City
Herts
AL7 1BU
England, Telephone +44 (0) 1707 353434
WARNING: In order to allow this equipment to operate in proximity to Industrial, Scientific and Medical (ISM) equipment, the external radiation from the ISM equipment may have to be limited or special mitigation measures taken.
WARNING: Shielded interface cables must be used with this product to maintain compliance with Council Directive 2004/108/EC.
iii
