Xerox 4Network setup Phaser 3250DN only, Supported operating systems, Using SetIP program

4Network setup (Phaser 3250DN only)

This chapter gives you basic information for setting up your printer for network connections.

This chapter includes:

•Introduction

•Supported operating systems

•Using SetIP program

Introduction

Once you have connected your printer to a network with an RJ-45 Ethernet cable, you can share the printer with other network users.

Switch the printer on.

Note

Holding the button down for 7~8 seconds (green light will blink fast) then releasing it, will print a configuration page with the IP address.

You need to set up the network protocols on the printer to use it as your network printer. Protocols can be set up by the following programs:

•CWIS (CentreWare Internet Service): A web-based printer management solution for network administrators. CWIS (CentreWare Internet Service) provides you with an efficient way of managing network devices and lets you remotely monitor and troubleshoot network printers from any site with corporate intranet access. You can download this program from www.xerox.com.

•CWIS (CentreWare Internet Service): A web server embedded to your network print server, which allows you to configure the network parameters necessary for the printer to connect to various network environments.

•SetIP: A utility program allowing you to select a network interface and manually configure the addresses for use with the TCP/IP protocol. This program is on the software CD that comes with your printer.

Supported operating systems

The following table shows the network environments supported by the printer:

Item	Requirements
Network interface	• 10/100 Base-TX

Item		Requirements
Network operating	•	Windows 2000/XP (32/64 bit)/2003/Vista
system	•	Various Linux OS including Red Hat 8~9,
		Fedora Core 1~4, Mandrake 9.2~10.1,
		SuSE 8.2~9.2
	• Mac OS 10.3~10.5
Network protocols	•	TCP/IP
	•	EtherTalk
	• HTTP 1.1
	• SNMP
Dynamic	• DHCP, BOOTP
addressing server

•TCP/IP: Transmission Control Protocol/Internet Protocol

•DHCP: Dynamic Host Configuration Protocol

•BOOTP: Bootstrap Protocol

Using SetIP program

This program is for the network IP setting using the MAC address which is the hardware serial number of the network printer card or interface. Especially, it is for the network administrator to set several network IPs at the same time.

Note

If you want to setup DHCP network protocol, go to the http:// developer.apple.com/networking/bonjour/download/, select the program Bonjour for Windows due to your computer operating system, and install the program. This program will allow you to fix the network parameter automatically. Follow the instruction in the installation window. This program does not support Linux.

1Insert the driver CD provided along with your machine.

2Open the X drive. (X represents your CD-ROM drive.)

3Double click Application > SetIP

4Open the language folder you want to use.

5Double click Setup.exe to install this program.

6From the Windows Start menu, select Programs > Xerox Phaser 3250 > SetIP > SetIP.

7Select the name of your printer and click “ ”.

Note

If you cannot find your printer name click “	” to refresh the
list.

4.1 <Network setup (Phaser 3250DN only)>