2Unpack the machine and check all the enclosed items.
3Remove the tape holding the machine tightly.
4Install the print cartridge.
5Load paper. (See "Loading paper" on page 5.4.)
6Make sure that all the cables are connected to the machine.
7Turn the machine on.
Caution
•When you move the machine, do not tilt or turn it upside down. Otherwise, the inside of the machine may be contaminated by toner, which can cause damage to the machine or bad print quality.
•During installation of the print driver, your operating system is automatically detected and the common paper size you use is set. If you change operating systems, you will have to change the paper size through the printer properties page.
Altitude adjustment
The print quality is affected by atmospheric pressure, which is determined by the height of the machine above sea level. The following information will guide you on how to set your machine to the best print quality or best quality of print.
Before you set the altitude value, find the altitude where you are using the machine.
| Value |
|
|
1 | High 3 |
|
|
|
|
2 | High 2 |
|
|
3 High 1
4 Normal
1Ensure that you have installed the printer driver with the provided Printer Software CD.
2
You can also click Status Monitor on the status bar in Mac OS X.
3Click Printer Setting.
4Click Setting > Altitude Adjustment. Select the appropriate value from the dropdown list, and then click Apply.
Note
If your machine is connected to a network, CWIS (CentreWare Internet Service) screen appears automatically. Click Machine Settings > Setup (or Machine Setup) > Altitude Adj. Select the appropriate altitude value, and then click Apply.
1.5 <Introduction>
