Xerox 96, 4635, 180 manual Printers

PRINTERS

Note: The DocuPrint MICR NPS models utilize the same hardware and operating system as the non-MICR NPS models. However, the Image Development systems have been modified to enable MICR font reproduction.

Processor feeder trays Two processor feeder trays are located in the main part of the printer:

•

•

The main tray (tray 1) holds up to 1100 sheets of 20 pound or 80 gsm (grams per square meter) paper.

The auxiliary tray (tray 2) holds up to 600 sheets of 20 pound or 80 gsm paper.

Each tray can handle paper from 8 x 10 inches/203 x 254 mm to 9.02 x 14.33 inches/230 x 364 mm.

7x10 inch (178x254mm) enablement The optional 7 x 10 inch enablement feature allows your DocuPrint 4635 NPS and 180 NPS to print on paper sized from 7 x 10 inches/ 178 x 254 mm to 9.02 x 14.33 inches/230 x 364 mm.

Note: The 7 x 10 inch enablement feature is not available on the

DocuPrint 96 NPS.

Inverter The inverter is part of the inverter feeder/stacker module. It allows for proper collation of the print job. It directs printed output to the sample tray, when required. It also directs output to optional third-party finishing devices in the proper orientation.

High-capacity feeder There is a high-capacity feeder (HCF) tray located in the bottom half of each feeder/stacker module (trays 3, 4, 5 and 6, depending on the number of feeder/stacker modules installed).

Each HCF tray can hold up to 2600 sheets of 20 pound or 80 gsm paper.

Note: When configured, each HCF tray can handle paper sized from 7 x 10 inches/178 x 254 mm to 17 x 14.33 inches/432 x 364 mm. To feed papers smaller than 8 inches/203.2 mm, an optional 7 x 10 inch enablement kit must be installed. 17-inch/432 mm paper can be fed only short edge first.

An elevator moves the tray up or down when it is in use. The HCF trays have Paper Level switches which detect the position of the elevator to determine the fullness of the tray. Paper Size switches detect the size of the paper loaded in the trays.

High-capacity stacker The 4635 NPS and 180 NPS printers can contain up to four high- capacity stacker (HCS) bins as part of the feeder/stacker modules (stacker bins A, B, C and D). The 96 NPS printer can contain up to two high-capacity stacker (HCS) bins as part of the feeder/stacker modules (stacker bins A and B).

3-2 XEROX DOCUPRINT 96/4635/180 NPS SYSTEM OVERVIEW GUIDE