Xerox 701P21110 manual Preparing to print a tape job, Importing resource files

Managing and printing jobs from the Tape Client

Saving a tape You can save a tape client setup including the following areas of client setup the Tape Client window:

•Input Device

•Output Control

•End of Job

•Document

To save a tape client setup:

•Click Save Setup in the Job Setup area to save the setup under its current name, or

•Click Save As... in the Job Setup area to save the setup under a new name.

To delete a tape client setup, click Delete.

Preparing to print a tape job

This section describes tasks that you perform to access the Tape

Client and set up a tape job for printing.

NOTE: The parameters that you specify on the Tape Client window override the settings of the queue to which the job is sent.

Importing resource files

In order to print a job from tape, the resources (forms, fonts, JDLs, JDEs, etc.) that are required by the job must be loaded in the “lcds” resources folder on the DP 2000 Series EPS system disk. If any of the resources that are needed for your job are missing from this folder, you must import them from the media on which they reside (diskette, tape, or another folder in the UNIX file system on the DP EPS controller). To import resource files to the “lcds” folder:

1.Click Administration on the DocuSP Print Services window.

2.Click the Lcds Resources tab to display the list of resources that are currently in the “lcds” folder.

2-4 Tape Client Job Submission Guide