■VPS

Selects whether to create Virtual Presence Speaker (VPS) using the front, center, and surround speakers. When VPS is enabled, the unit creates front VPS when no front presence speakers are connected, and creates rear VPS when front presence speakers are connected but no rear presence speakers (p.56).

Settings

Off

Disables Virtual Presence Speaker (VPS).

On (default)

Enables Virtual Presence Speaker (VPS).

 

 

Video

Configures the video output settings.

•Depending on the installation height of the surround speakers, VPS may not be effective. In this case, set “VPS” to “Off”.

■DAC Digital Filter

Selects the digital filter type of the audio DAC (digital-to-analog converter) to have favorite sounds.

Settings

 

Removes out-of-band noises by the filter with steep attenuation

Sharp Roll-off Type

characteristics.

 

It has a tendency to produce clear sounds.

 

 

 

Removes out-of-band noises by the filter with gentle attenuation

Slow Roll-off Type

characteristics.

 

It has a tendency to produce soft sounds.

 

 

Short Latency Type

Reduces the audio delay caused by the DAC internal digital filter.

(default)

It has a tendency to produce responsive and rhythmical sounds.

 

 

■Analog to Analog Conversion

Enables/disables the video conversion (p.148) between the analog video jacks (COMPONENT VIDEO, S VIDEO and VIDEO).

Settings

Off

Disables the video conversion between the analog video jacks.

Enables the video conversion between the analog video jacks.

On (default) Converted video signals are output from the MONITOR OUT jacks only.

•This function works only when “Monitor Out Assign” (p.118) is set to “Main” (default) and “HDMI OUT2 Assign” (p.118) is set to “Main” (default) or “Zone4”.

•The unit does not convert 480-line and 576-line video signals interchangeably.

•Only 480i/576i-resolution video signals can be output from the S VIDEO and VIDEO jacks (p.148).

■Video Mode

Enables/disables the video signal processing (resolution, aspect ratio and video adjustments).

Settings

Direct (default)

Disables the video signal processing.

Processing

Enables the video signal processing.

Configure the settings in “Resolution”, “Aspect” and “Adjustment”.

•When “Video Mode” is set to “Direct”, the unit transmits video signals with the least circuitry in order to reduce video output delay.

CONFIGURATIONS ➤ Configuring various functions (Setup menu)

En 111